How does a step work on an RV?

The gear linkage has a metal arm that moves the step in and out. When the motor moves the gear, the gear moves the metal arm either in or out which, in turn, moves the step.

What should the voltage be on an automatic step RV?

Disconnect the power cable from the motor. Then use a multi-meter to check for a DC voltage reading of around 12 volts when the door switch is activated. NOTE: It’s not important whether the voltage is positive or negative. The motor rotates in the reverse direction when the polarity is reversed (negative voltage).

How many Prest O fit RV steps are there?

Prest-O-Fit 2-0313 Outrigger RV Step Rug Castle Gray 18 In. Wide . Only 11 left in stock (more on the way). . . Only 19 left in stock – order soon. . . Temporarily out of stock. . Usually ships within 2 to 4 weeks. . Only 2 left in stock (more on the way). . . Only 3 left in stock (more on the way).

Why is the step motor on my RV not working?

If a positive or negative voltage is present when the door switch is activated, then the step motor is getting power, but not working. The step motor is likely bad and needs to be replaced. WARNING: Be careful where you place your hands and arms when reconnecting plugs on the step.

What kind of electric steps do I need for my RV?

The Kwikee Electric Step by Lippert Components is designed to automatically retract and extend when the coach door is closed and opened. Replacement motor for electric steps. When you enter and exit your RV you want to be sure to have proper stability under your feet every time.

How to repair an automatic step-RV with Tito?

1 Disconnect the main connector to step and controller unit 2 Remove the bolts securing the controller board (leave wires connected) 3 Replace the controller board with the new one and secure it with the bolts 4 Move each wire from the old controller to the new controller 5 Reconnect the main plug to the step 6 Verify proper step operation

Where is the gear linkage on a step RV?

Refer to the Lippert manuals for your specific Kwikee step model for the correct wiring. You can find the manual for your Kwikee step model here. The motor is mounted on top of the gear linkage with three bolts. It drives the gear linkage in forward or reverse when activated by the controller.