How do I know if my starter relay is bad on my refrigerator?

The Shake and Rattle Test Unplug the start relay from the compressor and give it a shake. If you can hear rattling on the inside of the start relay, then the part is bad and will have to be replaced. If it’s not rattling and appears to be in good condition, you may have a problem with the actual compressor.

How do you test a motor starter relay?

Set your multimeter to be on the Ohms scale. Place one probe on the lead on the ignition circuit terminal and the other on the ground lead. The reading should be less than 5 Ohms. If it’s more than that, the starter relay is faulty and needs to be replaced.

Why does my refrigerator make clicking noises when I put food in it?

Food will start to spoil, and you’ll be able to physically feel no cold air when you put your hand into the fridge. To fix a faulty start relay, you will need to do the following; The compressor is going to be located next to the coil condenser. The coil condenser is located on the bottom of the back of the fridge.

What should I do if my refrigerator is making a rattling sound?

Unplug the start relay from the compressor. Shake it gently and listen for a rattling sound. If you do hear rattling, it indicates that the start relay needs to be replaced. Visit a hardware store with your old start relay in hand.

What to do if your refrigerator is not cooling?

To confirm that the start relay is the problem with your fridge, disconnect the power from the refrigerator and pull the start relay out from its socket on the side of the compressor. Give it a shake. If it rattles, the start relay is faulty and needs to be replaced.

How can I tell if my Refrigerator start relay is faulty?

Within a short time it will try again without success. To confirm that the start relay is the problem with your fridge, disconnect the power from the refrigerator and pull the start relay out from its socket on the side of the compressor. Give it a shake. If it rattles, the start relay is faulty and needs to be replaced.

What to do if your refrigerator keeps clicking on and off?

Unplug your refrigerator from the power supply. Move the fridge away from the wall so you can access the rear panel. Locate the compressor; the start relay will be mounted to the side. You should be able to remove the start relay by hand.

Why does my refrigerator make a rattling sound?

Locate the compressor and attached start relay (a small box attached to the compressor). You may need to remove the back panel to access it. Unplug the start relay from the compressor. Shake it gently and listen for a rattling sound. If you do hear rattling, it indicates that the start relay needs to be replaced.

Why does my freezer make a clicking sound?

The compressor is a motor which compresses the refrigerant and circulates the refrigerant through the evaporator and condenser coils. Use a multimeter to test the continuity between the electrical pin…s on the side of the compressor. If there is an open circuit, the compressor is defective.

Why does my Dometic 2 way refrigerator not light?

1) once you open the access door outside, you can see the wires that apply 12volts to the refer 2) Disreguard the use of a second person to ignite the refer, your model when turned on gas, ignites by the turning of the know 3) as it does not click, to light the ignition module is suspect