How do you drain an indirect hot water cylinder?
How do you drain an indirect hot water cylinder?
How to drain the hot water cylinder
- Turn off the immersion heater and the boiler.
- Isolate the cylinder from its supply.
- Run the kitchen hot tap until it stops.
- Locate the draincock at the bottom of the cylinder.
- Place an old towel underneath the draincock.
Is it safe to drain an indirect water heater tank?
Watch out: what you describe may be unsafe; that is, if you drain the indirect water heater tank but leave its heating coil hooked up to the heating boiler and the boiler running, the tank may be damaged; I would not do that without first checking with the manufacturer.
Why is my SuperStor indirect water heater not working?
The hot water pipes to the Superstor indirect water heater tell us that the boiler is trying to heat the water in the water tank. But if you are getting NO hot water in the home, do you mean no water flow or water flows but is cold? The potential causes are different.
Why is my hot water tank not draining?
If you turn on the hot water at a faucet and nothing comes out, this is an indication the supply valve was never reopened after draining the tank. Remove the metal plate on the front of your hot water heater, if it’s gas operated, and look through the glass panel to see if the pilot light is on.
Where are indirect fired hot water heaters located?
Indirect fired water heater tanks for domestic hot water, such as the SuperStor TM are usually located close to the heating boiler and will have both cold and hot water lines leaving the tank to supply the building with domestic hot water and a loop of piping that runs between the [usually the] bottom of the tank and a nearby heating boiler.
Watch out: what you describe may be unsafe; that is, if you drain the indirect water heater tank but leave its heating coil hooked up to the heating boiler and the boiler running, the tank may be damaged; I would not do that without first checking with the manufacturer.
What should I do if my hot water heater wont drain?
Before opening the drain valve, a hose must be attached to it first, particularly if the drain is located some distance away from the water heater. If not, he or she may just leave it as is. Afterwards, the technician will open the drain valve.
The hot water pipes to the Superstor indirect water heater tell us that the boiler is trying to heat the water in the water tank. But if you are getting NO hot water in the home, do you mean no water flow or water flows but is cold? The potential causes are different.
Can a tankless water heater be used as an indirect heater?
Indirect water heaters have a limited hot water supply and require flushing, two issues a tankless heater is less prone to. Tankless water heaters can provide a certain number of gallons per minute (based on their rating) indefinitely.