Is the British Gas UP2 programmer faulty or faulty?

Hi I have a British Gas up2 programmer which does not switch the heating on until the hot water select button is switched to on and then off at which point the heating comes on is it the up2 which is faulty or something else? If it is the up2 which programmer would you recommend to replace it.Regards

Is there 5 / 2 mode on British Gas UP2?

If the jumper is left off altogether then it will offer 5/2 mode with different timers for weekdays and weekends, but there’s little point to that as 7 day programming starts with 5/2 and is then further customised for individual days (should you wish).

What are the jumpers on a British Gas UP2 timer?

Here’s a closer look at the three jumpers: The top and bottom jumpers should be left alone. The top switches between L inked (hot water and central heating on the same timer) and I ndependent (hot water and central heating on separate timers). The bottom switches between P umped and G ravity. The switch I needed to change was the middle one.

Who is the new programmer for British Gas?

Discussion in ‘ Plumbing and Central Heating ‘ started by braggit13, 17 Nov 2015 . Hi – wondered if anyone had any info on this new type of programmer BG are fitting now?

Who is the programmer for British Gas UP2?

Hi hope I’m in the right place?! very impressed with this site so decided to throw this one into the ring – We have a Baxter back boiler with British Gas UP2 programmer. The programmer has recently been playing up.

How does British Gas UP2 turn on central heating?

1. Tuned the light green 2. The Mid Position Actuator moved to the position it should be when just the CH should be on. 3. When I turn the HW on the valve moves back to the middle and both the HW and CH come on. 4. Turning the HW off again the CH goes off again

Why is my UP2 programmer not working properly?

The programmer has recently been playing up. Our heating is coming on at correct time but going off 2 hours earlier than programmed – regardless of how high we have thermostat (and red light is still on) – We have tried using the Advance button – but that is not clicking on at all so that hasn’t worked.

Is there a dual channel programmer for BG?

Have taken a look at the ID sticker and all it says is ‘Model-DCP’ with a description of Dual Channel Programmer… This model is made solely for Bg. Unlike their old models which were rebranded Drayton. What would you like to know? Yep, BG only model. Won’t find any instructions elsewhere. Thanks both for the confirm.