What does treble bleed mod do?

A treble-bleed (high-pass) circuit allows the highs to “bleed” (or pass) through the volume pot even as it is turned down. “It’s a common modification people have been doing for a while,” said Jonathan Parrish, a Fender engineer who designed the treble-bleed circuits in the American Professional Series guitars.

Does treble bleeding affect tone?

2: Treble bleed mod can have NO effect on your guitar tone when the volume pot is on 10 as the capacitor (and its resistor if present) are short circuited. Conversely, the higher the value of the resistor, the more treble is passed by the capacitor. However, a parallel resistor affects the taper of the volume pot.

Do you need a treble bleed?

Should you decide that a treble bleed circuit is for you, remember this: The modification is completely reversible, once installed it will not affect the tone of your guitar when the volume pot is turned all the way up (max volume). Basses and guitars with on board active circuits do not need treble bleed circuits.

What is a tone capacitor?

Tone capacitors are wired to the tone pot so the signal from the guitar pickup will pass high frequencies to ground when the tone pot is rolled down. The higher the value of the cap the wider the range of frequencies that get rolled off to ground. With lower value caps only the highest frequencies get cut off.

How do resistors affect guitar tone?

HOW IT WORKS: Simple. A Resistor is “Resisting” the flow of electricity, so, when you pull up, instead of sending 50% of the Humbucker to ground, it will only send, say, 33% of it. This allows you to have a stronger single-coil tone when pulled up.

What is the value of treble bleed?

Good working values to try are from 220 pF up to 1500 pF for the cap, and 100k-ohm up to 330k-ohm for the resistor. Our third treble-bleed network, shown on the right, consists of a cap with a resistor in series.

Do capacitors affect guitar tone?

Capacitors, or “caps,” are simple electronic components that are typically used in guitar electronics as filters or barriers for certain frequencies. High frequencies will pass through a cap, while lower frequencies are blocked. Using the filtering properties of a cap, we can affect the tone of the guitar.

What does changing the pots on a guitar do?

A potentiometer or “pot”, is a variable resistor that changes your tone or volume by increasing or decreasing resistance. Adding a capacitor or “cap” to the pot turns it into a simple EQ. Turning the wiper adjusts the amount of resistance and, in turn, determines which frequencies are allowed to pass.

What is a treble bleed mod and how does it work?

At its core, a treble bleed mod is the simple (and completely reversible) addition of a capacitor, on its own or paired with a resistor, to your guitar’s volume pot. That’s all it takes to ensure your treble “bleeds” through, no matter where you have your volume control.

What is the Kinman treble bleed circuit?

Series wiring – also known as the Kinman treble bleed – is for you. This circuit is extremely popular, as it protects your treble response nearly as well as parallel wiring, but maintains a familiar volume sweep. In this setup, the values of your chosen capacitor and resistor are incredibly interactive.

Can I Fix my Guitar’s treble bleed?

Luckily, there are as many fixes for treble loss as there are causes. And none are as popular – or as misunderstood – as adding a simple treble bypass filter – most commonly called a treble bleed modification – to your guitar.

What is a treble bypass filter and how does it work?

And none are as popular – or as misunderstood – as adding a simple treble bypass filter – most commonly called a treble bleed modification – to your guitar. At its core, a treble bleed mod is the simple (and completely reversible) addition of a capacitor, on its own or paired with a resistor, to your guitar’s volume pot.