Where is the fuse box on a 2010 Mazda 3?

Where is the fuse box on a 2010 Mazda 3?

The fuse box is located on the left side of the dashboard behind the cover.

Where is the fuse box in Mazda 3?

The fuse box is located on the front passenger’s side below the glove box (remove the glovebox bottom, turn the two clips and lower the fuse box down).

How do you reset the radio on a 2010 Mazda 3?

The default way to do it is to hold down the power button while You are turning the ignition off. Once it is off, while still holding the button, You want to turn the ignition back on. Once it is back on keeps holding the button down until You hear the radio beep. You may also use the radio reset code.

How do you change a fuse in a Mazda 3?

Fuse Replacement

1. Make sure the ignition is switched off, and other switches are off.
2. Open the fuse panel cover.
3. Pull the fuse straight out with the fuse puller provided on the fuse block located in the engine compartment.
4. Inspect the fuse and replace it if it is blown.

Where is the fuse box located on?

The main fuse box is located on the passenger’s side near the battery. To open it, push the two tabs as shown. All the electrical circuits in your car have fuses to protect them from a short circuit or overload. These fuses are located in three fuse boxes.

How much does it cost to replace a horn on a Mazda 3?

Mazda 3 Horn Replacement Cost Estimate. Labor costs are estimated between $56 and $71 while parts are priced at $61.

Why is my Mazda 3 radio not working?

Registered. Try holding BACK + NAV + MUTE for 10sec to reboot the system (with the car on). If that doesn’t work try pulling the radio fuse (also with the car on) wait about 5 – 10 minutes, replace the fuse.

Why my car radio is not working?

Common reasons for this to happen: Blown Fuse: One of the most common reasons for a car radio to stop working is a blown fuse. Damaged Antenna or Tuner: If the car’s CD player still works, but the radio itself doesn’t, then the problem most likely lies with either the antenna or the tuner.

How do you remove a car fuse?

How to Change a Fuse

1. Locate your car’s fuse panel.
2. Take off the fuse panel’s cover.
3. Locate the blown fuse.
4. Remove the broken fuse.
5. Insert a replacement fuse of the correct amperage—make note of the fuse panel and your owner’s manual on this one.
6. Keep a few extra fuses of various amperages in your glove box.