How can I see OSPF route?

To display general information about Open Shortest Path First (OSPF) routing instances, use the show ip ospf command. Use the show ip ospf command to display information about one or more OSPF instances.

How do I find OSPF route metric?

You can also change the parameters in the cost formula itself to accommodate a faster interface. However, when you change the OSPF cost formula, you should change it on all OSPF routers….OSPF Metric.

Interface	Cost(100Mbps/Bandwidth)
DS0(64kbps)	1562

How does OSPF determine route cost?

Open Shortest Path First (OSPF) uses “Cost” as the value of metric and uses a Reference Bandwidth of 100 Mbps for cost calculation. The formula to calculate the cost is Reference Bandwidth divided by interface bandwidth. For example, in the case of 10 Mbps Ethernet , OSPF Metric Cost value is 100 Mbps / 10 Mbps = 10.

How do I find the OSPF topology table?

To display Open Shortest Path First (OSPF) details about the topologies configured under the OSPF protocol instance, use the show ip ospf topology-info command in privileged EXEC mode.

Which command displays OSPF routes?

The show ip route [ospf | subnet mask] command can be used to display OSPF routes in the current routing table.

How do I find my OSPF database?

You can use one of three commands to see you own LSA-1:

show ip ospf database router self-originate.
show ip ospf database router 1.1. 1.1.
show ip ospf database router adv-router 1.1. 1.1.

How do I see OSPF in Packet Tracer?

This tutorial explains how to configure OSPF Routing protocol step by step with practical example in packet tracer….Summary.

Command	Description
Router(config-if)#ip address 192.168.250.250 255.255.255.0	Assign IP address to loopback interface.

What does show ip OSPF interface do?

The show ip ospf neighbor command can be used to find information about any OSPF neighborships, including the interface, the state, the neighbor’s address, and the neighbor’s router ID. To select a router ID for OSPF, a router goes through a process. When a router ID has been found, the process stops.