Where is the OBD II typically located in a car?

OBD-II diagnostic connector The OBD-II DLC (post-1996 vehicles) is usually located under the instrument panel on the driver side, though there are several exceptions. The SAE J1962 specification provides for two standardized hardware interfaces, called type A and type B.

Where does code reader go in car?

Plug your car code reader into the diagnostic link connector under the dash (engine off). Then start the vehicle and follow the auto code reading procedure in the instruction manual. Nothing can knock your day off track faster than a “Check Engine” light popping up on your dash.

Is my car OBD 1 or 2?

All cars and light trucks built and sold in the United States after January 1, 1996 were required to be OBD II equipped. In general, this means all 1996 model year cars and light trucks are compliant, even if built in late 1995. 2) There will be a note on a sticker or nameplate under the hood: “OBD II compliant”.

Where do I plug in my Hyundai Accent code reader?

OBD connector location for Hyundai Accent (2006 – 2011)

The OBD2 plug is located under the steering wheel on the left.
The OBD2 socket is behind the little plastic cover in the storage compartment.
Remove the little plastic cover. Here is the OBD2 plug.

Where is the OBD2 port on Hyundai Sonata?

The 2013 Hyundai Sonata OBD port location can be found to the right in the driver’s side footwell near the gas and brake pedals. The OBD port will allow You to connect a diagnostic tool to the vehicle and get fault errors.

Where does the FIXD sensor go?

Locate the OBD-II port: In the vast majority of cars, it is on the driver side under the dashboard, just above the pedals. Once installed, you can leave the FIXD sensor plugged in while you drive. If you cannot find the port, contact support, or go to fixdapp.com/find-my-port.

How do I know if I have obd1 or OBD2?

obd1 dizzy: and yet another way to tell is to take the dizzy off and spin the piece that goes in the head that attaches to the cam. if it clicks every time you spin it a little bit its obd1 but if it clicks after you spin it half way then its obd2. also the obd2 dizzy is lighter then the obd1 dizzy.

Is OBD the same as obd1?

OBD1 is connected to the console of a car, while OBD2 is remotely connected to the vehicle. 2. OBD1 was used during the earlier years of the car manufacturing industry, while OBD2 was only introduced in car models produced in the early 1990’s.