Are all toilet seat hinges the same size?

Due to the wide range of brands and shapes of toilets available, there is no one size fits all when it comes to replacing a broken toilet seat. The first thing to measure when shopping for a new toilet seat is the distance between the fixing points. These are the bolts that fix the toilet seat to the pan.

How do you install toilet seat on one piece toilet?

Install the HK36 hardware kit. Put one of the bolts with the phillips head through the quick-change mounting post and slide the bolt into one of the two anchors. Tighten clockwise by hand until it becomes too hard to further tighten by hand.

How are toilet seat brackets held in place?

Tighten the bolt, the rubber is squashed in place and hold the seat fixing down, simple and effective, if primitive to look at when you fit them, when in place you don’t see anything but your nice shinining new seat brackets.

Can a toilet seat be replaced in a back to wall unit?

Hi wayne_16, there are 2 possible scenarios. Firstly, the toilet seat may have been fitted to the pan before the pan was fitted to the back to wall unit. To remove you will need to take out the pan and get to the nuts underneath. You could just remove the seat, allow the nuts to fall and replace with well nuts (see below).

How do you remove nut from one piece toilet?

There are two of these, one on either side of the toilet base. Remove the nut cover by sliding a utility knife blade under the edge and twisting. The cover should pop right off, exposing the toilet bolt and nut. Use an adjustable wrench to loosen the nut by turning counter-clockwise.

How do you remove the bolts from a Toto toilet seat?

Unscrew each bolt by turning it counterclockwise with a No. 2 Phillips screwdriver. The bolts rarely stick, because friction holds the rubber sleeves into which they fit securely against the holes in the toilet. If the sleeve turns with the bolt, though, you’ll have to hold it steady from underneath the toilet.

Is it easy to replace a toilet seat?

Installing a new toilet seat is an easy two-minute job: Just set the seat in place and tighten the nuts. Removing the old seat, on the other hand, can be a frustrating ordeal. Often, the bolts that fasten the seat are so corroded that you simply can’t unscrew the nuts. But there’s no need to explode—we have the solution.

How do you change the hinges on a toilet seat?

Gently push both hinges on to the quick-change mounting posts until the bottom of the hinge is touching the porcelain. Now, simply move the locking hinges back to the right and the hinge will lock onto the quick-change post, securing the seat.