Can a bad condenser cause no spark?
Can a bad condenser cause no spark?
can a bad condenser cause weak spark? Weak spark is often the result of a bad condenser (and it’s a cheap part to replace). If you see higher resistance here, then you need to clean and check the connections and the circuit path to ground through the points. It can cause the ground to ground through the ecu frying it.
When to remove spark plugs from Onan engine?
This is a typical ignition module for an Onan engine. This is a typical ignition coil for an Onan engine. If you are getting no spark at the spark plugs, remove the plug wires
Where can I find Onan RV generator parts?
The spec letter of your generator is the last letter in the full model. (example 4.0BGE-1R/26100 E …. “E” would be the spec) For other Onan RV generator parts not listed on our website, please contact your local Onan distributor.
What to do if your Onan ignition is not working?
ONAN IGNITION SYSTEM TROUBLESHOOTING This is a typical ignition module for an Onan engine. This is a typical ignition coil for an Onan engine. If you are getting no spark at the spark plugs, remove the plug wires and check for continuity. No continuity means a bad wire. Replace both of them. Verify the condenser is not grounded.
How can I get Spark on my Onan?
Using a spare ignition rotor, Rotate the rotor infront of the module in same direction the motor turns over. It takes a full revolution to get a spark. You can not just pass a magnet in front of the module. Seems to act as a hall effect sensor. 6- I could then hear/see the spark as I made a full revolution. 7- If no spark.
What do you need to know about an Onan generator?
Before any evaluation of the controls, regulator or generator can proceed, the Onan engine must have oil and fuel, be in running condition and the 12-volt battery charged. The electronic governor, 151-0752, on Models BGM and NHM, Spec B and later, must be functioning properly.
This is a typical ignition module for an Onan engine. This is a typical ignition coil for an Onan engine. If you are getting no spark at the spark plugs, remove the plug wires
ONAN IGNITION SYSTEM TROUBLESHOOTING This is a typical ignition module for an Onan engine. This is a typical ignition coil for an Onan engine. If you are getting no spark at the spark plugs, remove the plug wires and check for continuity. No continuity means a bad wire. Replace both of them. Verify the condenser is not grounded.
Using a spare ignition rotor, Rotate the rotor infront of the module in same direction the motor turns over. It takes a full revolution to get a spark. You can not just pass a magnet in front of the module. Seems to act as a hall effect sensor. 6- I could then hear/see the spark as I made a full revolution. 7- If no spark.