Can a Worcester Bosch boiler still be installed?

I don’t have a Worcester Bosch boiler. Can I still install a Bosch EasyControl? What happens with the data from my EasyControl? Can I turn the home presence detection feature off and use my set timings instead? Can I program my hot water as well as my heating? I already have a Wave control. Can I upgrade to an EasyControl?

Why is my Stove Top igniter not working?

If your stove top burners function normally, then it is most likely an issue with the igniter. Otherwise, rule out the gas lines as the cause prior to suspecting the igniter. Clean any debris or dirt off your hot surface igniter using a toothbrush, blowing it gently after you are done.

How does a hot surface igniter work in a gas oven?

The hot surface igniter is used in modern gas oven burners to open the gas valve and to ignite the gas. As the igniter draws electric current it will heat to a high temperature and glow, as well as cause the bi-metal in the oven safety valve to warp and open the valve releasing the gas to be ignited. This sequence normally takes about a minute.

How can I troubleshoot my Bosch tankless water heater?

If the tankless water heater develops a problem, troubleshoot it before calling for service. Disconnect the power supply to the water heater before removing the cover. Inspect the water supply. Connect the supply line to the blue inlet on the water heater.

When does Bosch hot water Pilto ignition not ignite?

If you need assistance with getting in touch with an approved agent, please contact us at 1300 30 70 37 any time between 7:30AM and 6PM (AEST) on a weekday. Old bosch hot water pilto ignition do not ignite. Any ideas? My Bosch Optiflow 20 hot water system stays on when I am not using the hot water.

What to do if your Bosch pilot is running with no hot tap?

If the unit is running continuously with no hot tap on, it is possible that there is a leak in your hot water line. If this is the case and you can hear water running through the unit with no hot tap open, we recommend that you shut off the water isolation valve to the unit and phone a plumber.

How do you start a Bosch pilot ignition?

Start by making sure all your taps are off. There should be two valves on the pipes outside the unit. Turn them both off for 20 seconds or so, then turn them back on. Done. The unit locks-out if there is any air in the gas line. As its ignition is hydro-powered there is no need for lighter or matches. Good luck.

Can a Bosch hot water heater light pilot?

Listing monitored by Bosch Hot Water & Heating representatives. Just moved few days ago cannot get ‘stop’ button to come out to normal position. Did the WD40 silicone trick as shown on YouTube. So cannot light pilot at all! Cold showers. 4 buttons, lets just call them left to right 1 2 3 4.