Can you replace shower valve without removing tile?

Does the Repair Require Tile Replacement? This may require some cutting or removal of the tile around the shower valve opening to access the leak. While your plumber will take great care to cut or remove only enough tile as necessary, you could face some minor tile repair depending on the size of the opening.

Can a shower valve be fixed to a wall?

The shower valve can now be attached by the use of a shower valve fixing kit. If your pipes are completely accurate then I would recommend this. If they are a few mm out of level / 150mm centres, or you have a bit more cash to spend, then I would recommend this.

Do you cut the tile around the shower valve?

by Leaf Group. In every shower tile installation, the tiles must be cut to go around the shower valve. Depending on the size of the tiles, you can place the valve directly in the center of a tile or across two that are grouted in the center.

How are shower pipes fitted in a wall?

The walls surrounding the bath are then tiled with ceramic tiles, and grouted once the adhesive is dry. When fitting the tiles around the pipes, you must ensure that the pipes are kept level, perpendicular to the wall, 150mm apart and centred where you intend them to be.

What’s the best order to install shower tile first?

What’s the best order to do this? Then should I tiles the wall first? If so, is it best to mark the position of the new shower unit and tile to overlap, still leaving an area of plastered wall behind the shower, or should I tile everywhere and mount the shower over the tiles?

How to tile the back of a shower wall?

1 Run a damp sponge over the backer board in the area you intend to tile. 2 Spread Thin-Set along the first section of your tile row. 3 Turn over the trowel to the notched side and comb over in one direction. 4 Use a small amount of the excess mortar and spread it onto the back of a tile with the notched side of the trowel.

How do you install a tub shower valve?

Test-fit the crosspieces’ fit and saw little slices off one end until it fits snugly without nails. Hold the tub-shower valve against the bottom crosspiece. Line up the plastic face of the valve with a piece of 1-inch scrap lumber, which is actually ¾ inch deep, tacked to the front face of the stud.

What’s the best way to center a shower valve?

Your goal is to center the shower valve between studs 12 inches apart. A little mark at the midpoint of the plates, in line with where you expect the faucet and shower valve to be, helps for the next stage of this project.