Can you use 10-2 wire for a water heater?
Can you use 10-2 wire for a water heater?
Most water heaters are wired with 10-2 w/Ground shielded cable. For long distances you may need to go with heavier wire. When you use this type of wire both the white and the black will serve as hot conductors. The bare ground wire will also be connected to the neutral lug.
Does tankless water heater need dedicated circuit?
A tankless water heater will require a dedicated circuit as specified by the installation manual of the unit that has been selected. If you need additional space in the panel for the circuit breaker then a quad circuit breaker may be allowed as specified by the make and model of the panel.
How to hook up a tankless water heater?
I bought an EcoSmart 18 Tankless Water Heater. How do I hook up the wires from the two double pole 40 amp circuits inside the tankless water heater? David, from the information you have provided, make sure to keep the wire sets from “circuit breaker A” separate from the wires from “circuit breaker B”.
How to reset or reboot Titan tankless water heater?
Resetting the water heater is a simple process that can be performed at home in no time with little to none technical knowledge. For safety precaution we have removed the instructions on how to reset the Titan Water Heater. Please call the manufacturer’s techinical support line at 888-Titan-80 (888-848-2680) or the main line 305-876-9010.
Do you need to wire a hot water heater to a gas tank?
In cases where you are replacing a gas tank with an electric, you will likely need to run cable (2-pole, 30-amp breaker with 10-2NM cable) from the circuit to the tank. If the circuit breaker is already running a line to the water heater’s location, you can proceed to step 1.
What kind of wiring do I need for my eco 18 water heater?
I am hooking up the wires to two double pole 40 amp circuits. My confusion is wiring the unit. I have the wires on one color coded so I know which wires go to which breaker. In the Eco 18 there are two sets of connections. Breaker A has an L1 black wire and an L2 Red wire. Breaker B has the same.
I bought an EcoSmart 18 Tankless Water Heater. How do I hook up the wires from the two double pole 40 amp circuits inside the tankless water heater? David, from the information you have provided, make sure to keep the wire sets from “circuit breaker A” separate from the wires from “circuit breaker B”.
Resetting the water heater is a simple process that can be performed at home in no time with little to none technical knowledge. For safety precaution we have removed the instructions on how to reset the Titan Water Heater. Please call the manufacturer’s techinical support line at 888-Titan-80 (888-848-2680) or the main line 305-876-9010.
In cases where you are replacing a gas tank with an electric, you will likely need to run cable (2-pole, 30-amp breaker with 10-2NM cable) from the circuit to the tank. If the circuit breaker is already running a line to the water heater’s location, you can proceed to step 1.
I am hooking up the wires to two double pole 40 amp circuits. My confusion is wiring the unit. I have the wires on one color coded so I know which wires go to which breaker. In the Eco 18 there are two sets of connections. Breaker A has an L1 black wire and an L2 Red wire. Breaker B has the same.