Does the pilot light stay on in a water heater?
Does the pilot light stay on in a water heater?
Gas and propane fueled water heaters use a small flame to ignite the burner. This small flame is called a pilot light and it stays lit at all times. The same is true with a pilot light. If the pilot light goes out, your water heater won’t be able to ignite the gas burner and therefore, won’t be able to heat the water.
Why will my pilot light not stay lit on my water heater?
Lack of Combustible Air. Another reason your gas water heater pilot light won’t stay lit could be due to not having enough combustible air. Your water heater requires air to keep the pilot light burning. Otherwise, the flame goes out.
Can a pilot light be replaced on a gas water heater?
If this is the problem, in most cases, it’s easily resolvable with the above steps. If your gas water heater has a closed burner chamber or doesn’t have a pilot light, it’s much more difficult to access. To do this replacement, you most likely need a professional to fix this type of thermocouple.
Where is the pilot light on a Rheem hot water heater?
It is a small, bulb-shaped device located near the pilot aperture. When it is working properly, it generates a small electrical current to keep the gas valve opened when heated by the flame. A common problem with Rheem water heaters is a loose thermocouple that falls slightly out of position.
How big should the pilot light be on a thermo couple?
The thermo couple tip should 3/8″ ABOVE the “pencil Pilot Tip”, should read about 30mv. 2. Once opened the burner door. Manufacture requires installing a new gasket around the burner door to prevent CO and air leakag.
If this is the problem, in most cases, it’s easily resolvable with the above steps. If your gas water heater has a closed burner chamber or doesn’t have a pilot light, it’s much more difficult to access. To do this replacement, you most likely need a professional to fix this type of thermocouple.
It is a small, bulb-shaped device located near the pilot aperture. When it is working properly, it generates a small electrical current to keep the gas valve opened when heated by the flame. A common problem with Rheem water heaters is a loose thermocouple that falls slightly out of position.
The thermo couple tip should 3/8″ ABOVE the “pencil Pilot Tip”, should read about 30mv. 2. Once opened the burner door. Manufacture requires installing a new gasket around the burner door to prevent CO and air leakag.