How big of a hole do you need for a shower drain?

The size of the drain hole depends on the size of your shower’s drain opening. Most shower drains utilize a 2-inch pipe.

Can a hole saw be used to drill a shower?

The size of the hole saw will be the exact same size as shown on the plumbing fixture template layout from the fixture manufacturer. Hold the center 1/4-inch drill bit of the hole saw perpendicular to the shower wall over the previously drilled pilot holes. Start the drill and gently push forward, allowing the drill bit to cut into the material.

What’s the best way to drill a fiberglass shower?

Start the drill and gently push forward, allowing the drill bit to cut into the material. Keep an even forward pressure when the hole saw engages the fiberglass surface. If possible, have someone hold the suction end of a vacuum cleaner near the hole saw while cutting.

What’s the best way to remove a shower drain?

Lifting the Shower Drain Out Grasp both of your pliers firmly and lift the shower drain out of the hole. Lift the drain slowly to avoid denting or otherwise damaging the drain. Keep your grip consistent as you lift the drain out. Avoid holding the pliers too tightly or too loosely. Inspect the drain after removal.

How do you drill a hole for a shower pan?

Drill 3/16-inch holes in the flange at each stud location. Check to see if the shower drain hole lines up with the existing shower drain. If the hole does not align, trace the hole location onto the substrate and remove the shower pan.

The size of the drain hole depends on the size of your shower’s drain opening. Most shower drains utilize a 2-inch pipe.

How big of a hole do you need in a subfloor for a shower?

If you’re changing the drain orientation in a shower, be sure to modify the subfloor without disturbing the places it connects to the joists to access the drain line for the shower. Shower drain holes will need to be just over 2 inches to accommodate a standard-sized pipe.