Info

The hedgehog was engaged in a fight with

Read More
Tips

How do I dry the ground under my mobile home?

How do I dry the ground under my mobile home?

The installation of a moisture barrier on the ground under the home can help reduce the wetness and the resulting moisture rising up to the bottom of the home at the bellyboard (sheet plastic material that seals the bottom of the home). Repairing any openings in the bellyboard will also help to reduce the moisture.

Do pipes freeze in mobile homes?

Manufactured Homes Can Be More Prone To Pipe Freezing Unfortunately, mobile homes are very prone to pipes freezing because they are smaller and have thinner materials making up their walls and foundation. The process of making sure your mobile home stays protected is different than in a stationary home, as well.

Where is the water shut off valve in a mobile home?

Most mobile homes also have a second main shutoff valve, usually located somewhere near the water heater. This will be a valve located before the water heater, not the valve on the pipe running from the water heater. This indoor main shutoff valve is generally located near the floor.

When should I drip my faucets in a mobile home?

When the weather is very cold outside, let the cold water drip from the faucet served by exposed pipes. Running water through the pipe – even at a trickle – helps prevent pipes from freezing.

Where is the water supply line in a mobile home?

In mobile homes, you’ll also find that the piping systems are configured differently. In on-site homes, the supply line, which allows water to reach home fixtures, is generally located inside the walls. In a mobile home, the supply line will likely be found beneath the floor.

Why is my water running in my mobile home?

If you hear thumping when your water is running it is likely from your water lines not being strapped properly and it happens a lot. In lots of older mobile homes, you’ll find water supply lines run through cabinets or floor joists without straps. There is a product called hammer arresters that will help but a plumber will need to install it.

When to shut off water lines in mobile homes?

For a more hands-on solution, make sure that you run all your water lines regularly during winter. If no one will be staying in the home you should empty all the lines of water and shut off the water supply to the home for that period. Mobile homes tend to move and settle long after placed at a location.

Are there any plumbing problems in a mobile home?

As for plumbing leaks, they can be expected to damage the floors — where the pipes are located — rather than the walls. Certain types of wood may soak up the water like a sponge and rot. Leaks, clogs, low pressure and bad odors are just a few of the problems you might experience living in a mobile home.

If you hear thumping when your water is running it is likely from your water lines not being strapped properly and it happens a lot. In lots of older mobile homes, you’ll find water supply lines run through cabinets or floor joists without straps. There is a product called hammer arresters that will help but a plumber will need to install it.

Can a water line be repaired in a mobile home?

Water is the kiss of death in a mobile home so extreme care should be taken to be sure leaks are quickly discovered and fixed. Unfortunately, the variety of materials used, the terminology and the sizing issues, all combine to make water line repairs much more difficult then they should be.

How does the plumbing work in a mobile home?

The plumbing inside a mobile home is pretty much the same as it is for any site-built home. Each fixture has (or should have) individual shut-off valves. Shut-off valves at the toilet, under the sinks, and even at the water heater can be used to turn off the water supply for that particular fixture.

Where does the water come from in a manufactured home?

The water comes through 1 line and then branches at the water heater so some water can get heated, from there a hot and cold line runs parallel to the faucets, tubs, etc. Drain or waste lines are usually 3″ ABS.