How do I factory reset my Polycom Group 500?

How do I factory reset my Polycom Group 500?

Using the paperclip, press and hold the restore button. While holding the restore button, press the power button once. Continue to hold the restore button for approximately 13 seconds, until the front LED starts flashing alternating blue and amber. Then release it.

How do I reset my Polycom RealPresence touch?

Ensure that the RealPresence Touch is powered down by checking that the LED light is off. Now, press and hold the factory restore button using a pin or straightened paperclip. While holding the factory restore button, plug in the POE cable. Wait until the LED turns green before releasing the factory restore button.

What is Polycom RealPresence 500?

Polycom® RealPresence® Group 500. Powerful video collaboration for group conferences. in a sleek design that is simple to use. The Polycom® RealPresence® Group 500 solution is ideal for conference rooms and other collaborative environments, from small meeting rooms to larger rooms with dual screens.

How do I factory reset my Polycom visual pro?

1. Power cycle the Visual+.
2. Wait for the initial light to turn on an off on the pair button.
3. Press and hold the pair button.
4. Let go the pair button when the light flashes.
5. The Visual+ should factory restore and reboot when completed.

How do I factory reset my Polycom HDX 7000?

Do a full factory reset by pressing and holding the reset button before turning the power on, and then continuing to hold the reset button for 20 seconds after power on. This procedure completely wipes the configuration and will also set the software back to the factory version installed at the time of manufacture.

How do you reset a poly G7500?

On the front of the G7500 insert a straightened paper clip through the factory restore pinhole. On the side of the Studio X50 insert a straightened paper clip through the factory restore pinhole. On the bottom of the Studio X30 insert a straightened paper clip through the factory restore pinhole.

How do I reset my Polycom Touch Control?

To reset and update your device to a newer software version.

1. You have to first download the update files.
2. Now, turn the device over and unplug the power.
3. Then, insert a paper clip into the small hole shown here.
4. Reinsert the power cable.
5. The device will begin to restart.

How do I reset my Polycom studio?

Reset Polycom Studio to Factory Settings

1. Unplug the Polycom Studio USB video bar to turn it off.
2. Find the reset pinhole on the bottom of the USB video bar.
3. Use a pin or paperclip to press and hold the reset button and plug in the USB video bar at the.

What is SIP in Polycom?

If your network supports the Session Initiation Protocol (SIP), you can use SIP to connect IP calls. The SIP protocol has been widely adapted for voice over IP communications and basic video conferencing; however, many of the video conferencing capabilities are not yet standardized.

How do you reset a Polycom RealPresence trio 8800?

rebooting the Trio and once the Polycom logo appears press all 4 corners of the screen. Wait until the Mute LED flashes and then let go and the unit will factory restore.