How do I fix error code F02?

Press the pause or cancel button on the Whirlpool washing machine to clear the F02 error code from the display, and try using it again. The error code is displayed when the washer takes more than eight minutes to drain, but may just be a glitch.

How do I fix my F2 code on my Kenmore washer?

A stuck contact on the pressure switch can stop the advancement of the wash cycle and keep the water from draining. A few taps on the top of the switch with a screwdriver handle can release the contact and fix the problem causing the F2 error code.

How do you reset a Kenmore Elite HE3 washer?

How to Reset a Kenmore Elite HE Washer

Press the “Stop” button twice, and then press the “Power” button. Video of the Day.
Choose a wash cycle (e.g. “Normal”), and then choose your wash options (e.g. “Hot/Cold” or “Cold/Cold”).
Press the “Start” button to complete the reset process and restart the washing machine.

How do you reset the codes on a Kenmore Elite washer?

How to Reset the FH Error Code on a Kenmore Elite Washing Machine

Look for the “Pause/Cancel” button on the washer control panel.
Press the “Pause/Cancel” button twice to cancel the wash cycle.
Check for kinks in the water supply hose while the washer does not have power.

How do I fix the UL code on my Kenmore washer?

Unplug the washer. Plug the U.I. back in and then plug the washer back in. Codes should then be cleared.

How do you fix the UL code on a washing machine?

If uL (unbalanced load) appears in display, the load is out of balance. The washer is running a load-balance correction routine. Allow the washer to continue. If the dial is flashing and the washer has stopped, redistribute the load, close the lid, and press START/PAUSE.

What does F2 mean on washer?

: The “F2” fault code indicates it’s taking too long to drain the tub of water in order to reset the pressure switch. The problem is that the washer is not always able to drain water so that the water level switch can reset. This can happen if the wrong type of detergent is used or if you are using too much.

What is a F2 error code?

In this case, the F2 error code indicates that the oven temperature is too high. The oven control board (clock) is responsible for measuring the resistance of the sensor circuit. It does not measure the actual temperature inside the oven.

How do I run a diagnostic on my Kenmore Elite front load washer?

3 Answers

With the washer empty, close the door.
Push “control/on” or “Start”
Select “Drain/Spin”
Select “No Spin” by pressing SPIN SPEED touchpad.
Push “PREWASH” option four times within 5 seconds. (If there is no PREWASH option, press RINSE HOLD 4 times in 5 seconds.)
C:00 should light up and begin the diagnostic.

How do I fix the OL code on my Kenmore Elite washer?

shortiemomma2, empty the washer and spin the basket to check if it rotates freely. If it does not, then something may be caught between the spin basket and the outer tub which could give you an OL code. Also check for any obstruction underneath the washer by the motor that could be interfering with the motor.