How do I fix the igniter on my Viking stove?

The Range Ignition System is Clogged With Food Debris

Unplug the unit.
Remove the burner cap.
Clean around the igniter, burner, and under the knobs with a small brush.
Remove any remaining debris with a Q-tip and alcohol.
Replace the burner cap, and plug the unit back in.

How do you light the pilot on a Viking oven?

To light the oven pilot, push in and hold the oven control knob while lighting the pilot with a match. Once the oven pilot is lit, continue holding the oven control knob in for 1 minute before releasing. Replace the oven bottom, racks and oven door. No adjustments are required for natural gas.

How do you light an oven with a bad igniter?

If your gas stove igniter is broken, most gas stoves can be lit with a match or lighter. Turn the gas dial to medium, then ignite your match or lighter. Hold the match or lighter close to the center of the burner, then wait 3-5 seconds until the burner ignites.

How do you clean an igniter on a Viking range?

Here’s how to clean the burner area and igniter:

Disconnect the range from its power source.
Remove the burner cap by lifting upward.
Using a toothbrush, gently scrub the area under the burner cap to remove grease and food particles.
Unclog the igniter with a metal pin or straightened paper clip.

Do Viking ovens have a pilot light?

There are no pilot lights on viking ovens. Sounds like your oven igniter below the floor inside your oven is just starting to fail and needs to be ordered and replaced. Oven igniters last about 6-8 years under normal use before they tend to start failing.

How do you clean a Viking oven igniter?

Remove the burner cap. Clean around the igniter, burner, and under the knobs with a small brush. Remove any remaining debris with a Q-tip and alcohol. Replace the burner cap, and you’re good to go!

How do you light a Viking oven without electricity?

In the case of a power outage, you can light the surface burners with a match on your electric ignition gas or dual fuel range or gas cooktop. Hold a lighted match to the burner, then turn the knob to the low position. The oven of your gas range is lit by electric ignition, eliminating the need for standing pilots.

Are Viking ovens self cleaning?

This range features a self-cleaning cycle. During this cycle, the oven reaches elevated temperatures in order to burn off soil and deposits. A powder ash residue is left in the bottom of the oven after completion of the self-clean cycle.

Why is the broiler not working on my Viking?

Confirm that the temperature knob is adjusted to “Broil” and not beyond it if the Viking oven’s broiler is not working. If the temperature control knob is too far beyond the “Broil” marking, the broiler will not operate.

Why does my Viking gas oven not start?

When igniter fails it causes many different problems in the oven. The oven will take longer time to start, it will fail to maintain temperature or will just not come on at all. Replacing the oven igniter will fix that problem.

What does it mean when your oven igniter is not working?

Like gas burners on your stove, the oven igniter may click when it is trying to ignite the gas. However, if it keeps clicking, this means the igniter isn’t lighting the gas, but it is still trying. It is best not to let an oven linger when it is clicking and not lighting as this means gas is still being released and building up.

How do you install an igniter in a gas oven?

You want to install the new igniter in that same position. You will want to begin by removing the mounts on the igniter and pulling upwards to reveal two wires. These need to be removed. Some igniters may be secured using wire nuts that will also need to be removed. When installing the new igniter, you want to handle it very carefully.

Why is the light not working on my Viking oven?

For a gas oven, it could be a faulty gas valve or gas igniter as well. It’s not recommended to do the oven repair by yourself as it can be dangerous. In case the light isn’t working inside your oven, it could be the faulty light switch, the failed control board, broken tumbler switch, the burnt light socket or just a bad bulb.

How does an electric igniter in a Viking stove work?

Hunker may earn compensation through affiliate links in this story. Viking stove ranges use an electrical ignition system to light gas coming out of the burner. Turning the gas control knobs at the front of the unit to the “light” setting causes the electric ignition to create a spark. The spark ignites the gas.

Why does the spark keep clicking on my Viking stove?

The spark ignites the gas. An ignitor that keeps clicking might not create the spark necessary for ignition. Replacing the ignitor or the ignition switch at the front of the stove may be necessary to repair the issue.