How do I identify my Genie garage door opener?

Most Genie garage door openers also have the model number under the light bulb cover on the power head or on the back panel. A lot of the newer Genie models also have the model on the outer cover of the power head, making it easy to tell which model you have from the ground.

Where do I find the code for my Genie garage door opener?

Programming Genie Intellicode Remote Transmitters

Gently press and release the Receiver Learn Code button on the power head receiver of your door operator.
After pressing the Learn Code Button once, press your transmitter button three times for your system to grab the frequency and code it in.

What are the models of the Genie garage door opener?

This technical diagram of replacement parts is for Genie Excelerator series screw drive garage door opener models H8000, H8000-07, H8000D, ISD990, ISD995, ISD1000, PRO99, PRO99-2IC, PRO99FN, CMD9900. * The Genie Excelerator Garage Door Openers have a Self-Diagnostic Troubleshooting light.

What to do if your garage door opener moves?

For series II wall console, you can remove the wires from the back of the wall console and touch them together to see if the garage door moves. If it does proceed with repairing or replacing the wall console. Replace the Genie wall console if needed with the correct one for your garage door opener model.

What kind of light does a garage door opener need?

Check if the Safe-T-Beams red LED light is flashing. It should be on and steady. (See safe-t-beam diagnostic light guide) Check garage door for binding.

How can I Erase my Genie garage door opener remote?

Press the transmitter button once more to test the system and start your door moving. **To erase all Intellicode remotes and wireless keyless entry, hold down on the learn button until the indicator light stops blinking, then proceed to Step 1. For Genie IntelliG, TriloG, SilentMax, PowerMax, GPower, and PowerLift Series Openers ( Intellicode II )

What do you need to know about a garage door opener?

Gears / Couplers / Brackets Circuit Boards / Sequencers Wall Buttons / Consoles Miscellaneous Door Parts View Product Menu By Manufacturer Genie Genie Remote Controls Genie Carriages & Inner Slides Genie Outside Touchpads Genie Infra-Red Sensors Genie Limit Switches Genie Gears / Couplers / Brackets Genie Circuit Boards / Sequencers

Where is the learn button on a garage door opener?

Learn buttons are located on the motor head near the terminal strip for wire connections. Within 30 seconds, press and hold the button on the hand-held remote. release the button when the motor unit light blinks. It has learned the code. If light bulbs are not installed, two clicks will be heard.