How do I install new cable on my csraftsman?

To install the new cable, install the upper end first and install the hairpin clip to hold it in place. Install the Z fitting on the cable in the center hole in the lower bracket and install the bracket on the shift rod. Adjust the bracket so there is no slack in the cable and tighten the 2 bolts to hold it.

How do you hook up a snow blower?

Tip the snow blower onto its nose so that you have access to the idler arm. Look at the holes in the idler arm and connect the drive cable to the hole with the paint worn off around it where the old cable was. Once the cable is installed, adjust the tensioner so most of the slack is removed from the cable.

How do I replace the auger control cable on Craftsman 536?

When to replace Auger Assembly on Craftsman snowblower?

This video provides step-by-step instructions for replacing the auger assembly on Craftsman snowblowers. The most common reason for replacing the auger assembly is if the snowblower isn’t throwing snow like it should and the blades look worn out. Click here to purchase Part #984-04393: http://www.repairclinic.com/PartDetai…

How do you replace the cable on a snowblower?

Remove the top bolt from the cable guide pulley bracket on the left, rear side of the snow blower frame. Loosen the bottom bolt and pull the bracket away from the frame enough to relieve tension on the cable. Pull the Z-fitting out of the control lever. Remove the bolts from the bracket. Z-fitting on control lever..

What is model number of Craftsman snow blower?

The issue now is my snow blower model is 247881700 and the cable part number is 946-04256. The information that you gave me is for model number 247.88755 and the cable part number 746-04256.