How do I keep my trimmer line from sticking?

Spray the string trimmer line with WD-40 So grab your WD-40 can and spray all of your line until it’s soaked. This stops the line from binding together and the line should subsequently work just fine. A silicone spray would also be an excellent option and tends to catch less dust than WD-40.

Is twisted trimmer line better than round?

Twisted string provides a cleaner cut than a round string in thick weeds and has comparable durability around hard surfaces. The reduced air resistance makes it operate with less noise and vibration of the trimmer head than other string shapes.

What causes a line trimmer head to stop?

Fortunately, it’s usually easy to replace a dull or broken cutting blade. If you keep stopping because the new line isn’t feeding out, you most likely have a problem with your trimmer head or spool of nylon line. Stop the engine.

What to do if your trimmer is eating the line?

If this does not do the trick disassemble the string spool head and check for dirt/debri (clean head) check for damage, rethread and try. If still no go the head must be damaged/worn and will have to be replaced. If still under warranty, use warranty for repaired/replaced/refund.

Where is the lever on a lawn trimmer?

This lever is located inside the trimmer head and works on centrifugal force, feeding out more line as the line wears away. The lever locks into nubs as it waits to release more line. Over time, this lever can wear down and it will allow the line to continuously feed out.

How does auto line work on a lawn trimmer?

Some trimmers are equipped with an auto-line spool, which is controlled by a lever. This lever is located inside the trimmer head and works on centrifugal force, feeding out more line as the line wears away. The lever locks into nubs as it waits to release more line.

What causes a trimmer line to get stuck?

The spool houses the wound trimmer line, located inside the trimmer head. If the line is too thick it can get stuck and fail to feed; if the line is too thin it may get overheated by friction when cutting, especially under heavier loads. If it gets too hot it can melt, fusing itself together on the spool.

What to do if the wound trimmer line Won’t Feed?

If the cap is damaged, replace it. The spool houses the wound trimmer line, located inside the trimmer head. If the line is too thick it can get stuck and fail to feed; if the line is too thin it may get overheated by friction when cutting, especially under heavier loads.

What’s the best way to cut line with a line trimmer?

Push the bump head down with one hand and pull out line with your other hand until you can touch the cutting guard with the tip of the line. You may have to remove the trimmer head cover and manually feed line through the port.