How do I know if my lawnmower coil is bad?

One of the symptoms of a bad lawn mower ignition coil appears when you are mowing the lawn and the mower gets hot and literally shuts off. The mower must cool down over a period of time and will start and run for awhile until it gets hot again, at which time it will shut off again.

How do you test a Lawn Boy coil?

If you have a multimeter, turn its dial to the 20 K ohm scale, and insert its red lead in the common jack and its black lead in the jack marked with the ohm symbol. Test the meter before checking continuity by touching the leads together and verifying that you get a reading close to 0.

What should the gap be on a lawn mower coil?

The air gap adjusts and sets the correct ignition timing on magnetic coil type engines for proper engine operation. The feeler gauge tool thickness is generally between . 006 and . 010-inches or between .

How often should the ignition coil be replaced?

The ignition coil on car is supposed to last around 100,000 miles or more. You will have reduced gas mileage when coil begins to go bad and becomes less able to transfer power. Your car requires more fuel to run, this means you will spend more money on gas than normal.

Why do small engine ignition coils fail?

The leading cause of premature failure of an ignition coil is due to a worn or bad spark plug ignition cable. A bad spark plug ignition cable will have a much higher than normal resistance. This high resistance causes a very high amount of voltage to be generated from your ignition coil’s secondary winding.

What is the gap between ignition coil and flywheel?

Replacing Ignition Coils or Armatures An ignition armature must be set at a precise distance from the flywheel. Your engine repair manual will provide the proper gap for your engine. Common armature gap ranges are . 006 – .

Should magneto touch flywheel?

The magneto should not touch the flywheel. In fact, you have to adjust the gap between the coil and flywheel magnets so that the flywheel magnet lines up directly with the magnetic coil and feeler gauge tool.

What is the clearance between the coil and flywheel?

Homelite advises that the gap between the ignition coil and the flywheel must be set anywhere from . 0012 to . 0013 inch for successful engine startup. If you’ve not replaced the ignition coil recently and your machine won’t fire up, it may be possible that you simply need to check the gap and reset it if necessary.