Info

The hedgehog was engaged in a fight with

Read More
Lifehacks

How do I make my bathtub drain go down?

How do I make my bathtub drain go down?

Take one cup of baking soda, one cup of vinegar and one of salt, if you want some extra power, and make sure there’s no water in the tub. Dump the baking soda into the drain, followed by the salt, and finally the vinegar.

Can a tub drain go straight down?

Bathtub drain plumbing does a lot more than allow your bathtub to drain the water at the end of your bath. The reason why drains don’t go straight down to the sewer is that while it would be more efficient and eliminate clogged pipes, it would also allow dangerous sewer gasses to seep into your home.

Can you remove the bathtub drain stopper?

Set the drain to its open position. Unscrew the knob on the top of the drain stopper to see if there is a set-screw underneath. If your drain stopper has a set-screw, use a small screwdriver or a hex key to unscrew it. Twist the entire stopper counterclockwise until it pulls free from its mounting post.

Why won’t my bathtub drain go down?

Another at-home trick to try when your bathtub won’t drain is to pour boiling water. You can also try a baking soda and vinegar mixture to clean out clogged bathtub drains. First, pour boiling water down the pipe. Then pour in about half a cup of baking soda followed by a cup of white vinegar into the drain.

How do you remove a drain stopper from a bathtub?

If your stopper does not have a visible screw set on the knob, but does not seem to unscrew, lift the stopper up and turn, looking for a small screw. Use a standard flathead screwdriver or an Allen wrench (hex key) to loosen the set screw. You shouldn’t have to remove the screw entirely to remove the stopper.

What to do if your bathtub drain is clogged?

Clean the strainer or stopper. You will find that hair and soap residue may have accumulated underneath the strainer or stopper, which is located in or over the drain. Remove any screws securing the strainer, and remove the stopper by twisting and lifting it. Scrub any gunk or hair that has accumulated.

What to do if drain stopper does not unscrew?

If your stopper does not have a visible set screw on the knob then turn the stopper counter-clockwise until the stopper unthreads from the strainer and move on to Step 6. If your stopper does not have a visible set screw on the stopper knob and does not unscrew then you may have one of two different styles of lift and turn stoppers.

What do you put on the base of a bathtub drain?

Apply plumber’s putty around the base of the new drain and screw it in using the drain wrench or the pliers as before. As you screw it in, some of the putty will come out around the seal. When you have finished screwing the drain in, you then need to scrape off this putty. Next, fit the screen if you have one and then fit the stopper.

How do you unscrew a bathtub drain?

Unscrew the shaft cylinder, which is the part of the drain stopper that fits into the drain opening. It is usually screwed into a threaded section of the drain opening. Depending on the design of the stopper, you may need to use a screwdriver, or you may simply be able to twist the drain stopper counterclockwise with your hand.

Can a drain stopper be removed from a tub?

It’s also important to know how to remove a bathtub drain stopper if it isn’t properly placed. A stopper that isn’t flush with the bottom of the tub when it’s engaged may not hold water very well, making bath time a hassle. Chances are good that you can troubleshoot and replace your stopper.

What do you use to remove tub drain flange?

If you have a stuck tub drain, the tub drain wrench with a socket wrench and another long plumber wrench should do the trick as we show in this how to remove bathtub drain flange and tub drain install video. You just need to create a long moment arm for maximum turning force, that’s how to remove tub drains.

How do you remove a push pull drain stopper?

How to Remove a Push-Pull Drain Stopper: Set the drain to its open position. Lift up on the drain stopper’s knob and turn it counterclockwise. After enough turns, the drain stopper should be unscrewed and come free from the drain opening.