How do I remove an ESL smoke detector?

The detector LED should stay on and an alarm should be indicated at the control panel. Use the system reset switch to reset the detector. To remove the detector from the mounting base, grasp the detector and turn it counterclockwise approximately 15 degrees. The detector should snap off of the mounting base.

Why smoke detectors should be installed?

Dead air space is the greatest reason why smoke alarms must be placed in specific areas of the home. Dead air space refers to the spaces in which air becomes trapped as there is no air circulation – making it impossible for smoke to reach the area.

When and how should smoke alarms be installed?

Where do I install them? In addition to the minimum requirement of one smoke alarm per level, Fire and Rescue NSW research recommends installing smoke alarms in all bedrooms and living spaces (including hallways and stairways) and even the garage. Avoid fitting smoke alarms in or near your kitchen or bathroom.

How far does a smoke detector have to be from a bathroom?

Smoke alarms shall be installed not less than a 3-foot (0.91 m) horizontal distance from the door or opening of a bathroom that contains a bathtub or shower unless this would prevent placement of a smoke alarm required by other sections of the code.

What is the code for smoke detectors in bedrooms?

Presently the California State Building Code requires that smoke alarms be located in 1) the hallway outside the bedrooms 2) in each bedroom and 3) on every floor regardless of whether there is a bedroom on that floor. The California State Building Code has required this at least since 2007.

What kind of light does a UTC 429C smoke detector use?

Call us! The UTC 429C is a low-profile, self-diagnostic, two-wire smoke detector that works on the light scattering principle. A pulsed infrared light-emitting diode serves as the light source, and a high-speed photo-diode as the sensing element.

How does the ESL 700 smoke and heat detector work?

ESL 700 Series Conventional Smoke and Heat Detector Installation Sheet Description The ESL 700 Series smoke or smoke with rate-of-rise heat detectors have field-replaceable optical chambers. The detector uses an optical sensing chamber to detect smoke and a fixed-temperature heat sensor to detect heat from fire.

What kind of smoke detector does GE Security use?

UTC (Formerly GE Security/ESL) 429C Photoelectric Smoke Detector. The UTC 429C is a low-profile, self-diagnostic, two-wire smoke detector that works on the light scattering principle. A pulsed infrared light-emitting diode serves as the light source, and a high-speed photo-diode as the sensing element.

How do you remove the head of a smoke detector?

To remove the detector head, turn it counterclockwise. If the locking tab was removed, insert a small screwdriver into the locking tab slot on the side of the base, and then press in while simultaneously turning the detector head counterclockwise (see Figure 5). Figure 5: Removing the detector head with the locking tab removed Wiring

Are there any recalls on ESL smoke detectors?

This recall involves thirty-three models of the 400 and 500 series Edwards (ESL)-branded and Interlogix smoke detectors hard-wired into a security system. Edwards and Interlogix smoke detectors are identical. The 2-wire or 4-wire detectors are round, white and measure 6 inches across by 2 inches high.

Where is the ESL code on a Interlogix smoke detector?

ESL, the date code and model are printed on a label on the back of the detector’s cover. ESL, the date code and model are printed on a label on the back of the detector’s cover. Radio frequency interference can cause the smoke detectors to fail to alert consumers of a fire.

What’s the difference between Edwards and Interlogix smoke detectors?

Edwards and Interlogix smoke detectors are identical. The 2-wire or 4-wire detectors are round, white and measure 6 inches across by 2 inches high. The smoke detectors were made for professional installation and used primarily in commercial buildings, schools, hotels/motels, apartments, dormitories and homes as part of the fire alarm system.