How do I reset my Digistat rf2?

How do I reset my Digistat rf2?

how to reset drayton digistat thermostat

1. 1st open the draws on the wireless room stat.
2. replace the 4 AA battery’s but do not close the draws.
3. take it to within 1 metre of the receiver.
4. Turn the mains off then on again.
5. Press button 1 hold it.
6. Press button 2 until the red light flashes(learn mode)

How to commissioning the Drayton digistat RF wireless system?

COMMISSIONING THE DRAYTON DIGISTAT RF WIRELESS SYSTEM. 1. Pop the Digistat unit off the wall and take over to SCR unit 2. Pull down battery drawers in Digistat unit and allow screen to go blank 3. Turn off the power supply to the SCR receiver unit and leave for 5 seconds 4. Turn on power to SCR unit and check red light is on 5.

How do you troubleshoot a digistat RF receiver?

A) Pull down battery drawers from Digistat unit and allow screen to go completely blank B) Turn off the power supply to the SCR receiver unit and leave for 5 seconds C) Turn on power to SCR unit and check red light is on D) Put the SCR unit into its manual override mode by pressing the override button No.2 once.

How do I Turn on the digistat wireless system?

1. Pop the Digistat unit off the wall and take over to SCR unit 2. Pull down battery drawers in Digistat unit and allow screen to go blank 3. Turn off the power supply to the SCR receiver unit and leave for 5 seconds 4. Turn on power to SCR unit and check red light is on 5.

Why is my Drayton digistat still in Learn Mode?

If the red LED is still on, ‘learn mode’ may have been selected by accident (SCR buttons 1 and 2 pressed simultaneously). To correct, open both RF battery the left and reprogramme RF with your desired time and temperature settings. attention of a heating engineer/electrician. a satisfactory signal is reinstated. itself for normal operation.

COMMISSIONING THE DRAYTON DIGISTAT RF WIRELESS SYSTEM. 1. Pop the Digistat unit off the wall and take over to SCR unit 2. Pull down battery drawers in Digistat unit and allow screen to go blank 3. Turn off the power supply to the SCR receiver unit and leave for 5 seconds 4. Turn on power to SCR unit and check red light is on 5.

1. Pop the Digistat unit off the wall and take over to SCR unit 2. Pull down battery drawers in Digistat unit and allow screen to go blank 3. Turn off the power supply to the SCR receiver unit and leave for 5 seconds 4. Turn on power to SCR unit and check red light is on 5.

How is the temperature set on Drayton digistat?

The indicator will how on the screen if the heating is turned on. allows you to set 6 time and temperature events per day. temperature to 20ºC. At 08:30, the temperature set point is day, until 16:30 when the temperature increases to 21ºC. The .

Why is my digistat RF unit not working?

Digistat RF unit. This may be caused by the batteries being dead (see ‘battery replacement’) or some temporary interference with the radio signal. To resend and test the signal, go to the Digistat RF unit. If the flame symbol is visible on the display, press the ‘–’ button until it disappears.