How do I reset my Hunter SRC controller?

How do I reset my Hunter SRC controller?

SRC Reset

1. Unplug the controller’s transformer and remove the battery.
2. Press and hold down the , and buttons.
3. Plug the controller’s transformer back in.
4. Release the , and buttons. The display should now show 12:00a. m.
5. All the memory has been cleared and the controller may now be reprogrammed. Reinstall the battery.

How do I reset my sprinkler controller?

How to Reset a Sprinkler System

1. Turn the control dial to the “off” position.
2. Press the “next” button to access the clear-memory feature. The display should flash.
3. Press and hold the “off” button until the display stops blinking.
4. Turn the control dial to the “run” position.

How do you reprogram a Rainbird?

How to Reprogram Rainbird

1. Check the time and date on the controller to make sure it is accurate.
2. Rotate the dial to the “Watering start time” position and press the “+” or “-” keys to reprogram the time of day the watering cycle begins.
3. Turn the dial to the “Days to water” position.

What is Hunter SRC Plus?

9. The Hunter SRC Plus is remote-ready for use with the SRR or ICR remote control system. The remote makes it possible for contractors and end-users alike to operate an system without having to walk back and forth to the controller. To utilize the SRR or ICR Remote Control System you must install the SmartPort® outlet.

What do you need to know about Hunter controller?

Hunter controllers allow you to start a station or an entire program manually. To do so, turn the dial to Manual Single Station or Manual All Stations, verify that the stations that you want to activate have run time, and turn the dial back to the Run position.

How to eliminate a delay on a hunter controller?

To eliminate a delay, start with the dial in the RUN position. Push and hold the minus button, while holding the minus button turn the dial to Set Station Run Times. The delay will appear, zero the delay out using the minus button. After doing so simply turn the dial back to RUN and the delay is eliminated.

How do you set station run times on a hunter controller?

Push and hold the minus button, while holding the minus button turn the dial to Set Station Run Times. The delay will appear, zero the delay out using the minus button. After doing so simply turn the dial back to RUN and the delay is eliminated. What is the little sprinkler icon that flashes on my display?

What should I do about noise coming from my Hunter controller?

Noise entering the controller through the “SmartPort” wiring. To fix this ERR message; install a shielded SmartPort wiring kit (Hunter Part #SRR-SCHW), available from your locally authorized Hunter distributor. The “SmartPort” may be wired incorrectly.

Hunter controllers allow you to start a station or an entire program manually. To do so, turn the dial to Manual Single Station or Manual All Stations, verify that the stations that you want to activate have run time, and turn the dial back to the Run position.

To eliminate a delay, start with the dial in the RUN position. Push and hold the minus button, while holding the minus button turn the dial to Set Station Run Times. The delay will appear, zero the delay out using the minus button. After doing so simply turn the dial back to RUN and the delay is eliminated.

Push and hold the minus button, while holding the minus button turn the dial to Set Station Run Times. The delay will appear, zero the delay out using the minus button. After doing so simply turn the dial back to RUN and the delay is eliminated. What is the little sprinkler icon that flashes on my display?

Noise entering the controller through the “SmartPort” wiring. To fix this ERR message; install a shielded SmartPort wiring kit (Hunter Part #SRR-SCHW), available from your locally authorized Hunter distributor. The “SmartPort” may be wired incorrectly.