How do I reset my salt level?

To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.

Why is my salt cell flashing?

If the “Inspect Cell” light flashes by itself it is an early indication that the salt generator needs a manual reset. Each cell is equipped with 500 operational hours and requires a manual reset once it expires.

How to change the salinity reading on aquapure?

•Press and release the “Temperature “ button within 5 seconds to enter the salinity calibration screen. •The system will display the salinity reading, press the up arrow to increase the reading and the down arrow to decrease the reading. •When the proper reading is reached press the “Temperature” button within 5 seconds to store it in memory. 15

When do you add salt to a Jandy pool?

1. Set Unit to “00” % for 24 Hours. Broadcast or Spread Salt into Shallow End of Pool. 2. Do not Add Salt through Skimmer, Main Drain or Surge Tank. Directions for Adding Salt:

Is the salt lake level ever going to be restored?

Perry and other scientists believe that historic lake levels will never be restored unless more water is allowed to reach the lake, yet future diversions totaling hundreds of thousands of acre-feet are proposed for the Bear River.

What happens if your body is sensitive to sodium?

Some people’s bodies are more sensitive to the effects of sodium than are others. If you’re sodium sensitive, you retain sodium more easily, leading to fluid retention and increased blood pressure. If this becomes chronic, it can lead to heart disease, stroke, kidney disease and congestive heart failure.

When does the check salt and inspect cell flash?

The ‘Check Salt’ & ‘Inspect Cell’ LEDs will flash when the cell reports the salt level is between 2400 – 2700ppm. In this condition chlorine is still being produced. The ‘Check Salt’ & ‘Inspect Cell’ LEDs will be ON when the cell reports the salt level is 2300ppm or less.

What should the check cell salt level be?

If it’s over 2600-2700 the check salt level may be related to the check cell light. It could mean your cell is failing but surely not if it’s only four months old. I hope your solution is this simple. I was told the salt level should be between 2800-3200. The salt level is currently 3200 and all other levels are within range.

What to do if your salt level is above 3200ppm?

If salt level is above the range, partially drain the pool and/or spa and refill with fresh water to achieve a salt level of 3200ppm, refer to page 9, Step D. If the salt level is not high, verify the correct cell is being used then reset (follow steps for How to Reset Average Salt Levels above)

How to reset check salt and check cell lights?

I went to my Aqua Rite box and looked to see what it was reading. When the system came and flow was established, the “check salt” and the “check cell” lights both flashed continuosly. I reset the check cell light by holding down diagnostic button. The check salt never stopped flashing. The salt readout on the digital display was 2300.