How do I reset my Whirlpool ice maker?

Press the on/off Switch

Remove the ice tray and cover plate (or just the ice tray).
Turn the switch from on to off.
Unplug the ice maker at the mains.
Wait 10 minutes.
Plug the ice maker in again.
Turn the switch from off to on.
Replace the ice tray and the cover plate as necessary.

What would cause my Whirlpool ice maker to stop working?

Clogged Water Filter A dirty water filter can be the culprit to a Whirlpool ice maker not working properly, but still producing some ice. Over time, the water filter becomes clogged filtering the impurities and sediment out of your water. This is its job! Experts recommend replacing your water filter every six months.

Is there a reset button on Whirlpool refrigerator?

There is no reset button on a refrigerator,but there are many things that can keep it from cooling. There is not a reset button on most models of refrigerators.

What would cause an ice maker to stop working?

Cause: A common cause for a clog is frozen water in the line. Cause: There is also a possibility that the water filter for the ice maker is clogged. Fix: Locate and replace the water filter. Filters for ice makers are typically located inside the refrigerator (to keep them from freezing).

Why did my Whirlpool French door ice maker stop making ice?

– Whirlpool fridge French door ice maker – iFixit Fridges made by Whirlpool. Ice maker stopped making ice. Thinking it’s my ice maker but just getting a second opinion. My ice maker stopped making ice. I pulled it out and there was frozen ice cube still in the mold.

What does red status light mean on Whirlpool ice maker?

Open the freezer door and immediately view the diagnostics red status light next to the ice maker’s on/off switch. -Two flashes repeated once means the ice maker’s optics are blocked or defective. -A steady on light for 5 seconds means the ice maker’s optics boards are working properly.

How can I tell if my Whirlpool ice maker is working?

If you find the water pressure is normal, you’ll need to use a multimeter to check for power going to the inlet valve. Also, without powering valve up, you can check the resistance of the valve coils using a multimeter, there should be 500-1500 Ohms.

When did the Whirlpool ice maker come out?

One other important note… Whirlpool redesigned the optics portion of this system around 2002 so there are two different diagnostic methods depending on which set of boards are installed in your refrigerator, pre or post 2002 ice maker models. “My Icemaker is not producing Ice.” “I can’t get any ice to come out of the dispenser.”

What to do if your ice maker is not working?

Inspect your ice maker’s water line to make sure there are no kinks or obstructions. If you find a kink, use a pair of plyers to straighten the water line out. Freezers and refrigerators have a door switch. The door switch turns off the ice maker when the door is open. If the switch fails, the ice maker will not work.

When to replace ice maker on Whirlpool refrigerator?

Before replacing the ice maker assembly, check the water inlet valve, water line, and fan. If none of these parts are at fault, and the freezer temperature is at least 15 degrees Fahrenheit, replace the ice maker assembly.

How long before the new ice maker fills with water?

How long before the new icemaker fills with water? If you have to install a new ice maker, then you will need to wait 24 hours for the ice maker to get to a low enough temperature to start making ice. If after 24 hours the ice maker is still not making ice, then there must be some other issue in the system.