How do I reset my Worcester thermostat?

In the event of a fault, the blue mains indicator light will flash if there is a fault. To reset the boiler turn the Central heating temperature knob anticlockwise to the “RESET” position and hold for approximately five seconds and then turn the knob back to the original temperature setting.

Why is my British Gas wireless receiver flashing red?

Make sure both battery compartments are out on the ‘Wireless Display’ and the screen has gone blank, takes about 2 mins to fade. Check that the receiver red LED is on. Push in the right hand drawer, then the left (it must be done in this order) The red LED on the receiver will flash for 7 secs and then go out.

What does the Red alarm light on the digistat SCR mean?

I have a Drayton Digistat SCR with a remote digitial temperature control. Unfortunately, the alarm light on the Digistat box is flashing red … read more Hi I have a vailliant Eco tec boiler with a Drayton digitsat scr controller. The alarm light is on constant red on the digistat so the boiler can’t fire up. So … read more

How to stop Red recieve light constantly flashing wireless digistat?

Turn the power off to the receiver and wait ten seconds. now turn it back on and wait for the red light to come on. The boiler may fire up but just ignore it. now press button one (btm one) and hold it down whilst pressing button two and hold until the red light flashes for a few times then stops.

How do you troubleshoot a digistat RF receiver?

A) Pull down battery drawers from Digistat unit and allow screen to go completely blank B) Turn off the power supply to the SCR receiver unit and leave for 5 seconds C) Turn on power to SCR unit and check red light is on D) Put the SCR unit into its manual override mode by pressing the override button No.2 once.

How does a Drayton digistat wireless system work?

I have a Drayton Digistat ‘SCR’ wireless system associated with my heating/hot water set-up. The room thermostat no is no longer in control, ie when the boiler is operating it doesn’t stop when the set temperature is reached so the temp. just keeps on rising.

Why does the digistat SCR alarm keep flashing?

I have a drayton wireless system and the digistat scr alarm keeps flashing. What is wrong? … read more drayton digistat+RF wireless system. does not seem to respond to thermastat. have turned up room setting number with no effect. ON Light is green on the scr unit. House is freezing. Any advice welcome … read more

Why is my Drayton digistat SCR not working?

ON Light is green on the scr unit. House is freezing. Any advice welcome … read more Have a Drayton RF I wireless digistat heating control system, and problem is the red Alarm light on the SCR receiver unit will not go out, and system is not recognising signal from thermostat.