How do I reset my Yamaha RX v467?

Connect power cord to mains and wait 5 seconds or so. While holding down “info” and “tone control” buttons, press “main zone” power button briefly and release, but keep “info” and “tone control” buttons pressed for at least 3 more seconds. The unit should power up.

What to do if your Yamaha RX v671 won’t turn on?

Get a matching replacement at Jaycar if the current one looks burnt out or the wire inside the glass tube is clearly broken. Gently push the new fuse into place (with the power cord still unplugged!) by pressing the ends into the clips – not the glass middle – and see if it the receiver turns on okay.

Is the Yamaha RX V471 receiver still working?

I have a Yamaha RX V471 receiver only connected to some polk speakers and ipod and we had a power blackout recently, previously it had been working perfectly. Whilst there was no power (still plugged in), I tried switching it on (with the remote) and it ‘weakly’ came on with the usual click which was weird, but it ‘died’ after that.

Why does my Yamaha rx-v573 not power on?

If it powers up and doesn’t go into ptotection mode then the issue was more than likely being caused by one of the connections. The most probably connections to cause such issues are those associated with speaker wires. Check the terminations at both ends for exposed copper and also ensure that none of the wires are damaged along their lengths.

How do you turn off a Yamaha receiver?

Push the power button, MAIN appear and then turn off. The Service manual talk about updating Firmware but I never found any RXV471-xxxx.bin file anywhere on the internet. Hold TONE CONTROL + INFO + POWER Buttons. Scroll all Main and Sub-Menus. Everything is ok.

Can a Yamaha rx-v483 receiver be turned off?

Assuming the reason for the protection has passed or been fixed, the unit can now be turned off and then back on with the “main zone” power button to restore normal operation mode. If the protector activates again, the fault is still present and the unit needs to be repaired, ideally by a Yamaha authorised repairer.

Why is there no sound on my Yamaha receiver?

When I turn on TV, receiver recognizes it (HDMI input light comes on) and, automatically, changes to the default input (AV4) TV speakers automatically turn off (if receiver is turned on). TV remote will then control volume on receiver. But still no sound.

What to do if your Yamaha rx-a1040 protection circuitry activated?

When the unit is in this condition, the standby indicator on the unit blinks if you try to turn on the power….REMEDY: As a safety precaution, capability to turn on the power is disabled. Contact your nearest Yamaha dealer or service center to request repair.” Has anyone experienced this before?