How do I wire a Whirlpool dryer?
How do I wire a Whirlpool dryer?
Shape ends of wires into hooks. To connect wires to terminal block, place hooked end of wire under terminal block screw (facing to the right), squeeze hooked end together, and tighten screw. Connect neutral wire (white or center) (C) of power supply cord to center terminal block screw (B). Tighten screw.
How do you hook up a universal dryer cord?
Instructions
- Expose the Wire Connection Block. Locate the electrical cover plate on the back of the dryer.
- Install the Cord. Insert the dryer cord into the hole near the terminal block.
- Connect the Cord Wires.
- Secure the Cord.
- Reattach the Cover Plate.
Are all 3 prong dryer cords the same?
The National Electrical Code currently requires 4-prong dryer outlets in all new home construction. Existing homes may still use 3-prong outlets. The switch to a 4-prong outlet was due to a flaw in the 3-prong outlet design. In a 3-prong outlet, the ground and neutral wires are contained in the same prong.
How do you replace the belt on a whirlpool dryer?
Steps Start by removing the lint filter. Using your 5/16th screwdriver, remove the two screws under the lint filter. Next, take the putty knife and place it in the opening between the top of the dryer and the front of the dryer. Pop up the top of the dryer and repeat on the other side. Flip the top out of the way.
How do I replace the motor in my Whirlpool dryer?
How to Replace & Reconnect the Motor on a Whirlpool Dryer. Look for the metal clips holding the front and the rear of the motor to the motor-mounting bracket. Insert a flathead screwdriver into one of the curved ends of the clip. Push down on the metal clip to release it from the bracket. Repeat for the clip at the rear of the motor.
How to reset a whirlpool duet dryer?
Step One: Inspect Your Power Source. The first step in tackling a troubleshooting or reset issue is inspecting your household’s circuit breaker or fuses.
How do you clean a whirlpool duet dryer?
How to Clean Whirlpool Gas Dryer Vents & Lint Traps. Remove the screws securing the round, metal vent from the back of the dryer, using a nut driver or screwdriver. Pull the vent off of the dryer vent outlet. Insert the dryer lint brush into the vent as far as it will go. Move the brush around and from side-to-side. Pull the brush out. Do this several times until there is no more lint on the brush.