How do you backwash a DE system?

How to Backwash a DE Pool Filter

Step 1: Turn off pool equipment.
Step 2: Rotate the valve to the “Backwash” position.
Step 3: Turn equipment back on and run the first cycle.
Step 4: Turn the equipment off again.
Step 5: Rotate the valve to the “Rinse” position.
Step 6: Turn equipment back on and run the second cycle.

How do you backwash an above ground DE filter?

How to Backwash an Above-Ground Pool

Turn off the pool pump.
Turn the valve to the backwash position.
Turn on the backwash valve and let water run through the backwash hose for 2 to 3 minutes, or until the water coming out runs clear.
Turn off the pump.
Put the filter valve on the rinse position.

How to backwash the water out of a de filter?

How To Backwash Your DE Filter Step-by-Step Guide Turn the power to your filter system off and then turn the multi-position valve to the one that states backwash or pull open and twist the push or pull valve on the backwash gate. Turn your filter system on and run it for 2 minutes in order to backwash the water out of the backwash valve or port.

What does it mean to backwash a pump?

What is backwash pump? In terms of water treatment, including water purification and sewage treatment, backwashing refers to pumping water backwards through the filters media, sometimes including intermittent use of compressed air during the process. Backwashing is a form of preventive maintenance so that the filter media can be reused.

How do you backwash a sand filter in a pool?

If you’re wanting to backwash a sand filter yourself, here are the steps you should follow: Turn off your pool’s pump and filtration system. Clamp the backwash hose to your water outlet. Set the filter value to BACKWASH and ensure the handle locks in place. You’ll see water flow through those the hose or equipment in the view glass.

What’s the best way to run a backwash hose?

If you have a backwash hose that is installed, it is a great idea to place it flat on the ground with the hose pointed towards an area that you don’t mind water sitting for a while. After a few minutes, shut the filter system off. If you have a multi-position valve, then turn it to rinse and then turn the filter on again and run for 1 minute.

How do you backwash a de filter in a pool?

To backwash a DE filter, follow these steps: Turn off your pool’s pump and filtration system. Set the filter value to BACKWASH and ensure the handle locks in place. Turn the pump on and you’ll see water flow through the view glass. Wait until the filter view glass is clear. You can alternate between backwash and rinse a few times to remove the DE.

What happens when you backwash a pool pump?

The process of backwashing dislodges trapped debris and contaminants, flushing them out through your value’s waste line or a hose that is connected to the pool pump. When the filter media is clean, the pressure gauge is lower and water can easily flow in and out of the system. How often should you backwash your pool?

How do you backwash a de filter skimmer?

If the bumping process does not reduce pressure or improve filtering, follow the instructions below to backwash a DE Filter. Turn off the pump and clear leaf basket in the skimmer and the motor to be sure there is good water flow. If not already connected, attach a backwash hose to the port labeled “backwash” at the bottom of the tank.

How often do you backwash a de filter?

In a slow downward motion and a rapid upward motion, move the bump handle up and down 5-7 times. Restart filter and resume normal operation. If the bumping process does not reduce pressure or improve filtering, follow the instructions below to backwash a DE Filter.