How do you complete a Chevy drive cycle?

How do you complete a Chevy drive cycle?

A complete driving cycle should perform diagnostics on all systems. A complete driving cycle can be done in under fifteen minutes….To perform an OBDII Driving cycle do the following:

1. Cold Start.
2. Idle.
3. Accelerate.
4. Hold Steady Speed.
5. Decelerate.
6. Accelerate.
7. Hold Steady Speed.
8. Decelerate.

Does changing instrument cluster change mileage?

The short answer is no. Replacing the instrument or gauge cluster won’t reset the mileage.

How long do you have to drive to complete a drive cycle?

Preparation for it will take eight hours but, all in all, a basic drive cycle test should take around 30 minutes to complete, with about 20 minutes of actual driving.

How do I make my catalyst monitor ready?

7 Steps to Follow When Catalyst Monitor Not Ready

1. Make Sure the Engine Light is Off.
2. Check if your Vehicle has a Coolant Temperature.
3. Let the Engine be Idle for 2 Minutes.
4. Drive the vehicle at a Steady Speed of 55 MPH.
5. Decelerate your Vehicle’s Speed at 20 MPH.
6. Again Speed Up.
7. Stop the Vehicle.

How many miles do I need to drive to reset computer?

So why is the light still on? Here’s something you probably don’t know: after clearing the car’s computer you will need to drive for about 50 to 100 miles. As you drive your car the computer will monitor all the sensors and register the results.

Is it possible to roll back mileage on a digital odometer?

Digital odometers can be rolled back by removing the vehicle’s circuit board to change the odometer reading, or using rollback equipment that hooks right into the vehicle’s electronic circuit.

How do you reset the odometer on a Chevy Silverado?

To reset the odometer on a chevy silverado, turn the key to the run position and push the reset stem five times. With the odometer displaying, hold the stem in for 30 seconds.

How many miles do you need to drive to reset computer?