How do you install a toilet on a concrete slab?
How do you install a toilet on a concrete slab?
Use Tapcon anchors or a similar type of masonry/concrete screws to fasten the toilet flange to the concrete slab. If using a plastic flange ring, be careful not to crack the ring by screwing the anchors in too far. With the toilet flange in place, you are ready to install the toilet with a new wax ring.
Can a tile floor be raised for a toilet?
Even 1/4-inch-thick tile over a layer of thin-set adhesive can leave the toilet flange far enough below finished floor level to make it difficult to get a good seal. Two wax rings might get the job done, but a well-sealed toilet is one of those things it isn’t wise to gamble on. A better solution is to raise the height of the flange.
What’s the best way to raise a toilet?
Clean the top of the existing toilet flange thoroughly with a rag. Apply a thin bead of silicon caulk around the top edge of the flange. Place the extension ring on top of the flange and align the mounting holes so that they are above open spaces in the flange while maintaining the correct positioning of the toilet bolt slots.
Is it OK to raise the toilet flange after tile installation?
Another option for raising a toilet flange after installing thicker flooring is to use a push-in or expansion-type flange. Toilet flange extension rings aren’t permitted by some plumbing codes. Check with your local building department. Safari Plumbing: Should You Replace Your Toilet Flange When You Replace Your Bathroom Floor?
What’s the best way to install a toilet on a concrete floor?
Use a pencil or grease pen to mark the drill holes around its circumference. A masonry drill is required to bore holes into which the concrete screws are a placed. Once the flange is screwed down tight, the heads of locking bolts should be fitted into the grooves on the flange.
Even 1/4-inch-thick tile over a layer of thin-set adhesive can leave the toilet flange far enough below finished floor level to make it difficult to get a good seal. Two wax rings might get the job done, but a well-sealed toilet is one of those things it isn’t wise to gamble on. A better solution is to raise the height of the flange.
How to install a new toilet flange on a concrete slab?
Place the T-bolts upside-down in the new toilet flange so that the threaded shafts are sticking up. This step is all about the placement of the flange, not about installing the toilet. Having the bolts in place helps you better visualize how the toilet will be positioned. Continue to 5 of 7 below.
Clean the top of the existing toilet flange thoroughly with a rag. Apply a thin bead of silicon caulk around the top edge of the flange. Place the extension ring on top of the flange and align the mounting holes so that they are above open spaces in the flange while maintaining the correct positioning of the toilet bolt slots.