How do you remove the top of a Kenmore washer model 110?

Grab the wiring harness by the plug at the back of the Kenmore top where it connects to the circuit board in the appliance. Pull straight up to release the plug and the wiring harness. Pull forward on the washer top to disengage the two locking tabs at the back, then lift off the top and set aside.

How do you reset a Kenmore washer model 110?

How to Reset a Kenmore Elite HE Washer

Press the “Stop” button twice, and then press the “Power” button.
Choose a wash cycle (e.g. “Normal”), and then choose your wash options (e.g. “Hot/Cold” or “Cold/Cold”).
Press the “Start” button to complete the reset process and restart the washing machine.

How do you clean a Kenmore washer model 110?

Step 1 – With your machine empty, run it full of hot water to the largest load setting. When the tub is full and begins to agitate, add 3 to 4 cups of distilled white vinegar to the water. Then add Â½ cup of baking soda. Allow the machine to agitate for a few moments, then turn off the machine.

How do you bypass the lid lock on a Kenmore Elite washer?

Turn off the washer and unplug the appliance. Locate the retaining tabs and/or screws that hold the top horizontal panel down. Look for the lid lock switch on the underside of the top panel and where it fits into the appliance. Put the lid back down and plug the washing machine back into the electrical outlet.

Can you bypass the lid switch on a Kenmore washer?

The lid switch on your Kenmore washer completes the electrical circuit when the lid is closed. If you do not have a volt-ohm meter, you can bypass the lid switch using a jumper wire to simulate the connection to the washer wiring harness.

How do you replace the lid on a Kenmore washing machine?

Use this guide to replace a faulty lid switch on your Kenmore 110 series washing machine. To avoid risk of electric shock, unplug the washing machine. Using a 5/16″ socket wrench or an adjustable wrench, remove the three screws from the top rear of the washer. Lifting from the rear, remove the top panel.

Is there a way to bypass the Kenmore lid switch?

The best way to test the lid switch is with a volt-ohm meter. If you do not have a volt-ohm meter, you can bypass the lid switch using a jumper wire to simulate the connection to the washer wiring harness. Unplug the Kenmore washer power cord from the wall outlet.

Where is the switch on a Kenmore washer?

Locate the lid switch wiring harness on the rear of the top panel. Grasp the wiring harness connector with your fingers and pull it away from the lid switch plug. Strip a 1/4-inch of insulation from each end of your jumper wire with a pair of wire strippers. Plug the washer power cord into the wall outlet.

How to replace the lid on a top load washer?

Push back on the control panel while sliding a putty knife under the right corner of the control panel to release the mounting clip. Repeat on the left side to release the console. Lay the console on the top of the washer.

Is the Kenmore 110 washing machine easy to use?

The Kenmore 110 Series is an easy to use home Washing machine created by Kenmore. Why won’t washer fill? These are some common tools used to work on this device. You might not need every tool for every procedure.