How do you replace a fuel line on a chainsaw?

How do you replace a fuel line on a chainsaw?

Instructions

1. Drain the fuel tank. Wear work gloves to protect your hands.
2. Remove the cylinder shield.
3. Disconnect the spark plug wire and remove the air filter.
4. Remove the fuel filter.
5. Remove the carburetor.
6. Remove the old fuel lines.
7. Install the new fuel lines.
8. Install the fuel filter.

Where do the fuel lines go on a chainsaw?

The (clear) fuel intake line runs from the top of the carburetor (straight nipple) and goes to the short post on the back of the primer bulb. The return line (blue) comes from the long post on the back of the primer bulb and goes into the bottom of the fuel tank.

How many cc’s is a Poulan Wild Thing 2375?

Where is the return line on a Poulan chainsaw?

Disconnect the fuel return line from the primer bulb. The fuel return line is secured inside the fuel tank by a plastic compression fitting (which prevents the line from being accidentally pulled from the fuel tank). Removing the fitting (and the return fuel line) requires a bit of patience and a good pair of hemostats.

How do you replace fuel lines on a chainsaw?

When it’s time to replace the chainsaw fuel lines, it’s important that you cut the new tubes to the proper length. Use needle-nose pliers to remove the tubes from the carburetor and pull them from the tank. When you remove the fuel line that feeds fuel to the carburetor, the small cylindrical fuel filter will pop off of the tube.

How to replace gas tubing on a Poulan Chain Saw?

Pull the fuel filter housing nipple from the carburetor fuel supply hose end. Unscrew the retaining screws and remove the engine cylinder shroud from the top of the chain saw engine. Unscrew the retaining screws and lift the starter housing from the engine chassis on the chain saw’s left side from the operator’s position. Always On.

Can a fuel line be broken on a Poulan?

Some models will have a remote fuel tank vent (and another piece of fuel line connecting it to the tank). Fuel lines are in constant contact with gasoline. Over time, the gas will begin to harden and deteriorate the fuel lines. Once hardened, the fuel lines are easily cracked or broken.

Where does the fuel line go on a Poulan chainsaw?

There is a line with the filter in the tank that goes to the bottom of. I’ve been trying to get the fuel system resolved on this Poulan and Poulan fuel line routing Chris-PA Where the Wild Things Are. I need to know where fuel line goes on a poulan chainsaw wildthing. Can you. I need fuel line diagram for poulan schematron.org does crankcase hose.

How do you replace the return line on a chainsaw?

Use snippers or scissors to cut the return fuel line as close to the fuel tank as possible. Remove the fuel cap. Using hemostats, remove the compression fitting (and the remainder of the return fuel line) from the inside of the fuel tank.

Where is the purge line on a Poulan?

There are multiple fuel lines found on most small engines. At a minimum, there will be a line carrying fuel from the tank to the carburetor, and a second line returning excess fuel from the carburetor to the fuel tank. Many models have a remote purge bulb, which adds a third line between the bulb and the carburetor.

How often should a Poulan chainsaw fuel filter be replaced?

The fuel filter should be inspected often, and replaced at least yearly. If the fuel filter becomes clogged, the flow of fuel will be restricted, causing the engine to not start, to run poorly, or to sporadically die. This article provides step-by-step instructions for replacing the fuel filter on a Poulan chainsaw. Let’s get started.