How do you replace a toilet tank?

How to Replace the Tank on Your Toilet

Step 1: Disconnect the Toilet from the Water Supply.
Step 2: Drain the Water from the Toilet Tank.
Step 3: Disconnect the Supply Hose on the Toilet Tank.
Step 4: Extract the Bolts on the Toilet Tank.
Step 5: Detach the Tank from the Toilet Bowl.

Is it hard to replace a toilet tank?

Replacing a toilet tank is a task most homeowners can do without a call to the plumber. Because the tanks and bowls may be sold separately, you can often buy just the tank. However, it is important to match the toilet manufacturer and model to ensure proper installation and function of the toilet when you’re done.

When should I replace my toilet tank?

According to the Energy Policy Act of 1992, toilets installed after 1994 must have a flush volume of 1.6 gallons per flush. Toilets manufactured before this policy went into effect used between 3.5 to 5 gallons. The bottom line on aging toilets? If you know your toilet is at least 25 years old, consider replacing it.

What’s the best way to replace a toilet bowl?

Using the same wrench or channel lock pliers, remove the nuts that hold the toilet tank in place. They should not be really tight as it is recommended to just hand-tight them to avoid breaking the porcelain tank or bowl. If the bolts start spinning, you will need a screwdriver to hold them inside the tank.

What to do if you have a leak in your toilet tank?

All of them are easy fixes. However, the first one requires removing the toilet and replacing the wax seal, so it takes more time than any of the others. If the leak is on the main water connection, you may need to inspect the connection hose as well as the water supply inlet/ballcock, and replace as necessary.

What to do if your toilet tank bolts are rusted?

If the bolt’s head is completely rusted (it happens), you may need an extra set of pliers to hold them while you try to turn the nut. When removed, place the tank on top of the toilet bowl, or on any other place that makes it comfortable enough for you to work on it. This is an optional but, highly recommended step.

Do you need to replace the bowl gasket on a toilet?

This is an optional but, highly recommended step. And it is the one you need to complete when you have a toilet leaking from the tank to bowl gasket. In this case, since you have already removed the tank, it makes sense to go ahead and replace this gasket as well.

How do you put a toilet tank on a bowl?

Insert the tank bolts and washers from inside the tank. Place the tank onto the bowl, aligning the shank of the bolts with the holes in the bowl. If the bolts extend too far over the washers and nuts, cut off the excess with a hacksaw. Secure the tank to the bowl by alternately tightening each tank bolt until the tank pulls down and meets the bowl.

How do you fix a toilet tank at Home Depot?

Turn off the water supply valve and flush the toilet. Disconnect the supply line from the tank and sponge the inside of the tank until it’s dry. Remove the fill valve using two adjustable wrenches. Take it with you to your local Home Depot store so you’ll be sure to get the right part.

What’s the best way to replace a toilet?

Here’s an overview on how to remove an existing toilet for replacement: Turn off the water at the shut-off valve located either on the wall or floor near the toilet. Flush the toilet to drain all the water from the tank and toilet bowl. Use a plunger to force any remaining water down the drain line.

How do you remove water from a toilet bowl?

Use a sponge to remove any remaining water in the tank or bowl. Also unthread the coupling nut between the water supply and toilet tank with an open-end wrench. Most tanks are held to the toilet bowls by two long brass nuts that you need to unscrew in order to remove it. Locate these nuts under the flange, towards the toilet bowl rear.