How do you reset the check engine light on a 2006 Dodge Cummins?

How do you reset the check engine light on a 2006 Dodge Cummins?

Turn the key to “ON” without starting and then to off. Do this 3 times in rapid succession and leave it in the “ON” position the third time. Watch your odometer and it will start spitting out codes. After it is done, turn the key off and get out.

How do you reset the check engine light on a Dodge Ram 2500?

Dodge Ram: How to Reset PCM and Check Engine Light

1. Step 1 – Remove the PCM fuse. First, park your truck and turn it off.
2. Step 2 – Reset the PCM. Get in the driver’s side of the truck, shut the door, and put on your seat belt.
3. Step 3 – Re-install the PCM fuse.

How do you clear the codes on a Dodge Cummins?

Using a code reader tool, connect to the ECM and find the “fault codes” tab….Follow these steps to clear the Cummins fault codes with a scanner:

1. Close the doors and insert the key into the ignition.
2. Cycle the key five times from “off” to “run” without actually cranking the engine.
3. On the fifth cycle, leave in run.

Is the Check Engine light still lit on Dodge Ram?

This article applies to the Dodge Ram 2nd, 3rd, and 4th Generation (1994-Present). It’s not uncommon for a check engine light to remain lit long after the issue setting it off in the first place has been fixed.

How to check codes on 03-07 Dodge Ram 5.9 diesel?

How to Check Codes on 03-07 Dodge Ram Cummins 5.9 Diesel 2500 and 3500 – YouTube In this Video I show you how to check any codes that may be coming up on your 2003-2007 Dodge ram 2500 and 3500’s with the 5.9L Cummins.

How to reset PCM and check engine light in Dodge Ram?

The reset procedure in your Dodge Ram is as easy as they come. First, park your truck and turn it off. Pull the hood lever under the driver’s side dash, and then pull the safety catch on the front of the hood to open it. Find the power distribution center (PDC); it will be a black box near the battery. Unlatch and open the cover of the PDC.

What are the warning lights on a ram?

The following are warning lights and indicators found in vehicles built by Ram. Click a link to learn more about each one. They are roughly ordered by importance, which tends to be by color (red, amber, yellow, orange, green, blue, gray), but there are over 70 of them so be patient!

This article applies to the Dodge Ram 2nd, 3rd, and 4th Generation (1994-Present). It’s not uncommon for a check engine light to remain lit long after the issue setting it off in the first place has been fixed.

The reset procedure in your Dodge Ram is as easy as they come. First, park your truck and turn it off. Pull the hood lever under the driver’s side dash, and then pull the safety catch on the front of the hood to open it. Find the power distribution center (PDC); it will be a black box near the battery. Unlatch and open the cover of the PDC.

What does a flashing check engine light mean?

A flashing check engine light is your Dodge Ram’s way of saying “I have a serious problem, don’t ignore me”. Most of the time, that serious problem is a misfire. This flashing light should not be ignored. When your engine is misfiring, it is dumping raw fuel into the exhaust.

What are the trouble codes on a Dodge Ram?

P0301 -P0312: Cylinder Specific Misfire- These trouble codes correspond with a specific cylinder misfiring (cylinder number corresponds with its place in the firing order).