How do you set the time on a ThermoSpas?
How do you set the time on a ThermoSpas?
Time Once the time is set, pressing the time button displays the time of day. To set the time, press ‘Time’ ‘Mode/ Prog’, then use ‘Warm’ & ‘Cool’ to select the hour. Once the hour is selected, press ‘Mode/Prog’ to select the minutes and adjust using ‘Warm’ & ‘Cool’.
What’s the best way to reset a timer?
The .Stop, then .Start methods worked as a reset. Other alternative way to reset the windows.timer is using the counter, as follows: So if you intend to repeat every 1 second, you can set the timer interval at 100ms, and test the counter to 10 cycles.
When does the spa go to sleep mode?
The spa will automatically revert to Economy mode after one hour (or instantly if you press ‘Mode/Prog’). Sleep Mode heats the spa to within 20° of the temperature set-point, but only during filtration cycles. The Sleep icon will be displayed unless the mode is changed. Additional Control Panels – supplied on some spa models
How to turn off pump 1 on the ThermoSpas?
Pump 1 Pump 1 is a 2 speed pump. Pressing once puts the pump into low speed, indicated on the LCD by a slow moving pump icon . Pressing a second time activates Pump 1 to high speed (icon moves faster). To turn off, press a third time (icon disappears from the LCD).
Time Once the time is set, pressing the time button displays the time of day. To set the time, press ‘Time’ ‘Mode/ Prog’, then use ‘Warm’ & ‘Cool’ to select the hour. Once the hour is selected, press ‘Mode/Prog’ to select the minutes and adjust using ‘Warm’ & ‘Cool’.
Where is the high limit reset button on a spa heater?
This is a red button found on many spa packs. It may be located on the heater and covered by a rubber nipple. Press the high-limit reset button. When this button is tripped, it will “click” in when you reset it. Turn on your spa and observe its operation.
How can I Reset my Digital spa heater?
A digital spa pack may not have a manual high-temperature reset switch. This is controlled by a sensor instead. If the heater element is not getting the proper amount of water flow due to pump problems or poor water level, the sensor will trip the heater and cause it to stop operating. Check the spa’s water flow for pump operation.
How do I reset the time on my pool pump?
A: To reset the time clock to the correct time, grasp the outer edges of the large yellow dial, and pull gently outward, towards you. This will disengage the dial and allow you to spin it in either direction. Set the current time to the center time pointer, pointing downward at 6 o’clock.