How do you troubleshoot LED pool lights?
How do you troubleshoot LED pool lights?
Check the circuit breaker panel that’s usually found on the side of your house. If the breaker that your pool light is on has been tripped, unplug whatever you just turned on or plugged in and then reset the breaker by turning it all the way off and then back on again. If that doesn’t work, you may have a bad breaker.
Which is the best Hayward led pool light?
Hayward ColorLogic LED pool light died so replaced it with IntelliBrite Color LED pool light from Pentair. Before switching brands, I contacted Hayward to ask if they improved the service life on the ColorLogic 2 series and I wasn’t impressed with their response. The color logic was great while it lasted.
Why is my Hayward colorlogic light going bad?
If splices all looked good then most likely it is the failing bulb. It does sound like the PCB board inside the Hayward ColorLogic is going bad, the exact same thing happened to me on my light. The downside to the LED lights that use a PCB board instead of a bulb is that the entire light fixture needs to be replaced when the board/bulb goes bad.
What should I do if my pool lights are not working?
In both cases, you need to pull the fixture from the pool in order to continue your troubleshooting process. Go ensure that your circuit breaker to the pool lights, the GFCI and the switch for the pool lights are all turned off.
What’s the problem with my colorlogic pool lights?
My pool has two colorlogic lights both wired to a single transformer box recently when I turn them on one will not light up for about an hour then it comes on. Any suggestions on what the problem could be? Hi! That is an interesting problem. Makes me wonder how old the lights are. I al so have a PM into someone that might know the answer.
In both cases, you need to pull the fixture from the pool in order to continue your troubleshooting process. Go ensure that your circuit breaker to the pool lights, the GFCI and the switch for the pool lights are all turned off.
If splices all looked good then most likely it is the failing bulb. It does sound like the PCB board inside the Hayward ColorLogic is going bad, the exact same thing happened to me on my light. The downside to the LED lights that use a PCB board instead of a bulb is that the entire light fixture needs to be replaced when the board/bulb goes bad.
When to turn off LED light on Hayward Aqua rite?
Step 1: Wait 60 seconds after the pump starts. Typically, the LED light should shut off after 60 seconds. If it does not, keep reading. Step 2: Verify that you have enough straight pipe before where you have installed your flow switch. There should be at least 12″ of straight pipe before the switch.
My pool has two colorlogic lights both wired to a single transformer box recently when I turn them on one will not light up for about an hour then it comes on. Any suggestions on what the problem could be? Hi! That is an interesting problem. Makes me wonder how old the lights are. I al so have a PM into someone that might know the answer.