How do you turn on a dome light?

Your dome light is controlled by a dial. Inspect the dome override button below the headlight switch. Push the dome light dial up (you’ll hear a slight click) to turn on the dome light.

Why are the lights not working on my coach?

Sounds like a possible transfer switch or fuse issue. With the 12 volt lights working when on shore power means the charger is working. Look for a large fuse between the batteries and the charger 12 volt output feed to the positive coach battery terminal (s). With a meter you should read a voltage at the positive terminals.

Why are the lights not working on my FMCA RV?

Welcome to FMCA ! Sounds like a possible transfer switch or fuse issue. With the 12 volt lights working when on shore power means the charger is working. Look for a large fuse between the batteries and the charger 12 volt output feed to the positive coach battery terminal (s). With a meter you should read a voltage at the positive terminals.

Why are the lights not coming on in my RV?

THAT MEANS YOUR BATTERY ISOLATOR (COULD BE DIODE-BASED OR SOLENOID BASED) IS NOT WORKING. BOTH BATTERY BANKS SHOULD BE CHARGED BY THE ALTERNATOR. Plugged in not running the Batteries are at 12.58.

Why are the lights not working on my Winnebago Vectra?

I have 1994 Winnebago Vectra Diesel Pusher and I’m having trouble with the lights not working off the coach batteries. I can get all appliances and lights to work when I’m plugged in, but not when it’s unplugged.

Why are there no lights on my front door?

Make sure your dome lights switch is set on door, it could just set for off. 57 people found this helpful. It could be a short or bad switch. Check to make sure the switch on the dash that controls the light brightness is not cut off. 17 people found this helpful.

Why does my Silverado not turn the lights on?

No that turns all the door sensors on our off. Only my driver side rear door doesn’t turn the lights on when that door is opened all other doors including the rear tailgate hatch work. I need to know where the door switch is for one particular door…

What to do if your interior light is not working?

Try glue-ing (or soldering) on a little “button” on the end of the switches and see if that solves the problem. I would venture to guess one of your door switches isn’t being depressed quite far enough. Try glue-ing (or soldering) on a little “button” on the end of the switches and see if that solves the problem.