How do you unclog a Kohler tub drain?

Put enough water in the bathtub or sink to cover the bottom of the plunger, block the overflow outlet with a rag, put the plunger over the drain, and push down and up five or six times. The pressure should clear any clog and open up the pipe.

How do you unclog a bathtub drain that is completely clogged?

All you need to do is pour a pot of boiling water down the bathtub drain. Then pour a mixture of one cup baking soda and one cup vinegar into the drain. Insert the drain plug, or close the filter, and wait 5–10 minutes. Finally, flush the drain with another pot of boiling water.

Will vinegar unclog a bathtub drain?

Baking Soda and Vinegar If you’re not a fan of using chemicals, this all-natural solution may help to unclog a bathtub drain. You may need to finish by pouring some boiling water down the drain, but this method can work well for mild clogs as the baking soda and vinegar activate to dissolve icky buildup.

How do you remove a Kohler drain?

Removing the Stopper

The ball rod holds the stopper in the drain. To reach the stopper, the ball rod needs to be removed first.
The ball rod is inserted into the side of the drain and attached with a nut.
To remove, unthread the rod nut, pull the ball rod out, and remove the stopper from the drain.

What to do if your bathtub drain is clogged?

Run water into the tub. If it leaks out, lengthen the stopper linkage to seal the drain better. If the drain doesn’t open to let the water out, shorten the stopper linkage. Bend a little hook on the end of a stiff wire (or a coat hanger) with a pair of needle-nose pliers and shove it through the clog.

How to unclog a tub drain without chemicals?

Here’s how to open and unclog the most common drain types. Heavy wire or coat hanger to bend into hook. About 80 percent of the time, you can fix slow-draining or clogged tub drains in about five minutes, without chemicals and without a $100 plumber bill. In most cases, you’ll only need a screwdriver and a stiff wire or a bent coat hanger.

What to do if hair clogs shower drain?

If it leaks out, lengthen the stopper linkage to seal the drain better. If the drain doesn’t open to let the water out, shorten the stopper linkage. Bend a little hook on the end of a stiff wire (or a coat hanger) with a pair of needle-nose pliers and shove it through the clog. Pull out the hair clog.

Clean the strainer or stopper. You will find that hair and soap residue may have accumulated underneath the strainer or stopper, which is located in or over the drain. Remove any screws securing the strainer, and remove the stopper by twisting and lifting it. Scrub any gunk or hair that has accumulated.

What to do if your bath clicker drain is not sealing?

If your bath clicker drain is not clicking or sealing properly, refer to the following troubleshooting information. Start with the stopper on the clicker mechanism and make sure it is tightened down all the way. The left photo (Fig. 1) shows the threads from the clicker assembly.

How do you unclog a tub with a plunger?

Remove the stopper of the bottom (main) tub drain. You may have to unscrew it or turn it back and forth a little while pulling up. Fill the tub with about one to two inches of hot water (not cold). Hot water helps dissolve soap in clogs. Place the cup plunger over the drain so the entire lip…

Why is my bathtub drain stopper not working?

Clean away any debris on the spring at the end of the stopper linkage. In many cases, a build-up of hair and soap scum can cause problems with the stopper. If necessary, adjust the connecting rod to lengthen it. This will increase the downward force of the spring against the rocker arm when the trip-lever is operated.