How do you use T max 3W?
How do you use T max 3W?
Place one T-Max® 3W G2 in the tanning room and one at the desired remote location. Connect the 9V @ 300mA power supply to the “Pwr In” screw terminal on the back of each T-Max® 3W G2. Plug each power supply into a 120VAC outlet. Connect the T-Max® 3W G2 in the tanning room to the tanning bed as described.
What is a Tmax timer?
The T-Max® Series timers are the industry standard for controlling your tanning salon. Now with our G2™ Wireless Modules you can control your entire salon without the need to run cables throughout your building. This makes the T-Max® Series the easiest and most versatile timers in the tanning industry to install.
How do you use a Tmax tanning bed?
Press the Up or the Down Button on the T-Max® 3A until the session time is displayed. If the display shows a 0, and you want to go directly to the maximum time, press the down button once. Press and release the Start/Stop button to start the session. If a delay other than 0 is entered, the delay will count down.
Can you bypass a timer on a tanning bed?
Simply unplug the remote timer system and insert Bypass Plug into tanning bed to determine if the problem lies in the remote system or the tanning bed. If your bed has 2 RJ22 connections in the back side you can use this plug to make the bed work without running the external timer.
Can you bypass the timer on a tanning bed?
Do tanning bed bulbs get weak?
By 500 to 800 hours of use, most tanning bulbs have lost enough potency that they should be replaced. It’s important to replace all of the bulbs at one time to avoid uneven light, and thus uneven tans.
Do tanning bed bulbs need to warm up?
Although the visible light coming from a tanning lamp is only slightly reduced when the air around the lamp is very cool (or very hot), the ultraviolet output is cut exponentially. Once the room is fully heated, allow the tanning bed to run for a full session to heat up to normal operating temperature.
Can the T-Max 3w/g2 be used as an independent timer?
The T-Max® 3W/G2 ™can be used as an independent timer, or can be used as a front desk controller to control another T-Max® timer in the tanning room for remote single bed control.
Is the T-Max® 3w/g2â„¢ wireless ready?
The T-Max® 3W/G2™ is also wireless ready. It can connect to a G2™ Access Point to communicate throughout your tanning salon without the need to run cables throughout your salon. For further details on the G2™ Wireless Adapters, click the link here.
How do I change the parameter number on my T-Max 3W G2?
Press and hold the Start/Stop and Up buttons together on the T-Max® 3W G2 until a “P-” appears on the display. Release the buttons. Once the buttons are released the display will read a.1 (point one). Press the Up and Down Buttons until the parameter number that you want is displayed.
How do I connect the tanning bed to the T-Max® 3W G2?
Connect the two wires from the tanning bed, for attaching to an external timer, to the “contact” screw terminals on the T-Max® 3W G2. Note: There may be many wires visible on the tanning bed. Two of these wires are specifically used for connecting the tanning bed to an external timer.