How does a self leveling headlights system work?

With a self-leveling system, electric servomotors react to the level sensor and keep the headlights aimed down at the road, no matter the position of the car. Self-leveling headlights are already required on new cars in Europe, and they’re required on all U.S. cars equipped with bi-xenon headlights.

Why is my Lippert ground control leveling not working?

I dont know if the leveling system is a 2.0 or 3.0. The display on the touch pad is blank. The back light comes on, but no words, It seems like everything else works, I can press the auto level button and it works. I can press the retract button and retract the landing jacks, I just cant see anything on the display.

Why is my LCI leveling system not working?

My lci electronic leveling system for winnabago has Jacks down and is indicating low voltage but I know that the batteries are fully charged and prior to shut down indicated 13.6v. This sounds like it is a ground issue. If your ground wire from the control module is grounded to the frame, I would try removing the ground and cleaning the surface.

How can I Reset my Lippert LCI leveling system?

My Lippert LCI leveling system is showing jacks down when the jacks are up. All the lights start blinking with break off and ignition on. Cannot lower jacks. Reset by pushing all four buttons just stops it for a second then lights start blinking again. Checked fuses. After a few minutes just the lights on left side blink.

What to do if your leveler is not level?

1. Insure vehicle engine is running, transmission is in park and park brake is set. 2. If emergency stop was activated by pressing any keypad button, press ‘RET’ and ‘ALL’ to reset legs. 3 AUTO POSITION DOES NOT LEVEL THE COACH Cause: The last position in memory was not level. Solution: Leveler System always returns to position in memory. 1.

What happens if no current is detected after leveler is activated?

During any operation if no current is detected from leveler after leveler is activated, the following occurs: 1. Warning alarm will sound. 2. Power is removed from the control box disabling normal operations. 3. The red and green LED’s for that leveler will blink on and off to indicate the system is in an error mode. Solution: To proceed, 1.

Why is my Atwood levelegs not turning off?

JACK CONTINUES TO CLUTCH AND WILL NOT TURN OFF Cause: Short jack extension followed by jack retraction. Solution: Put system in error mode by disconnecting one jack from power and pressing RET and ALL. Reconnect jack to power.