How much does it cost to replace copper pipe with PEX?

PEX meets building code nearly everywhere, comes with a 25-year warranty, and puts a smaller hit on your budget than copper. Replacing all of the plumbing in a 1,500 square foot, two-bathroom home with copper piping costs between $8,000 and $10,000. But using PEX would cost just $4,000 to $6,000, according to Gove.

How to replace a hot water heater shut off valve?

Take the time to find them. Shut off the next valve up the line. Locate the valve that is closer to the supply than the one you want to shut off. This might be the hot water heater, the house water shut-off in the house, or the main shut-off at the meter.

How to install or replace a dishwasher hot water supply line?

Whether you are installing a new dishwasher or just replacing the hot water supply line, here is a quick how to video. A wrench is all that is required, 15mm or a 5/8″. Try not to use channel locks, pliers or vise grips. Shut the water supply off, loosen off both ends there you are, install the new line and you’re done. Loading…

How to replace a toilet water supply line?

The first step for toilets or faucets is to turn the water off at the shutoff valve. Then remove the supply line from the shutoff using a crescent wrench, turn the nut counterclockwise. Typically water toilet water supply lines are hand tight at the fill valve. But pliers can be used to loosen them.

What’s the best way to replace a shut off valve?

Turn the water or gas back on. Check for leaks at the valve. There are different ways to do this depending on whether you’re working with a liquid or gas system. If you’re checking for water leaks, wipe the valve completely dry with a towel. Then, turn on the faucet or appliance and let it run for a few minutes.

How to replace a hot water supply line?

Tighten the connections with the adjustable wrench. Connect the opposite end of the lines to the connectors on top of the water heater and tighten them. Turn on the closest hot water faucet once again. Turn on the cold water supply valve to fill the tank. Leave the faucet on until it produces a steady stream of water. Turn off the hot water faucet.

How do you replace a water shut off valve?

Turn on the main water supply and open the newly installed supply valves. Let the water flow through the faucet to clear air in the lines. Check for leaks by feeling the fittings by hand or using a paper towel. Tighten as necessary. Follow these steps to replace water shut-off valves in your home.

How do you turn off a hot water heater?

If working on a hot water supply line, it’s a good idea to turn gas water heaters to the pilot setting and turn off electric water heaters. Open the faucet to drain the line. Place a bucket under the old valve. Removal methods vary according to valve type: If removing a solder-type valve, cut the supply line with a pipe cutter.

Where do you find the shutoff valve under the sink?

Here are the types of shutoff valves to help you identify what you have under your sink. Straight stop valves are typically found when the water supply pipe comes up from below the floor or cabinet. The fixture supply tube connects to the top of the valve in the same line as the supply pipe.