Is it bad to run a chainsaw full throttle?

Generally, two-stroke chainsaw engines are built to conveniently run at full throttle without an engine breakdown. Therefore, running at any throttle speed below the full throttle is not advised. Cutting a thick wood or timber while running at a low speed or throttle can cause the blades of the chainsaw to become dull.

Why does my chainsaw lose power when cutting?

The Job of the Carburetor Without the right amount of air and fuel in the piston cylinder, the 2-cycle engine in a Stihl chain saw runs inefficiently and the saw loses power. When the saw bogs down during cutting, it’s usually the high-speed screw you need to adjust.

How long should you run a chainsaw?

Depending on the type and usage, you can expect a gas Chainsaw to run between 15 and 40 min before you have to fill it up again. Most battery-powered chainsaws have a run time of up to 2 hours, but there are high-capacity power packs that will last much longer.

What RPM does a chainsaw run at?

Depending on your saw, the reading should be between 10,000 and 14,000 rpm. A chainsaw piston goes up and down in the cylinder 20,000 times per minute. The piston ring speed on the average chainsaw travels 2,500 surface feet per minute.

What causes a chainsaw to die at full throttle?

Over time, when your chainsaw has been running on full throttle, carbon deposits can build up in the exhaust port, muffler, or spark arrestor. This can result in one or more of these parts becoming clogged. When such a clog occurs, the exhaust gasses will not be able to exit the engine, and it will cause your chainsaw to die.

Why does my Poulan chainsaw stall when I Turn on the gas?

If the spark arrestor isn’t the culprit behind your Poulan chainsaw stalling, it is likely that the carburetor is clogged. The most common reason that the carburetor can become clogged is when fuel is left inside the chainsaw for far too long. Over enough time, the ingredients in the fuel can evaporate.

Is the Poulan chainsaw a good chainsaw?

The chainsaw has a smaller engine with a smaller carburetor that does the above-stated good and bad jobs! Though Poulan chainsaw is one of the leading homeowner chainsaws on the market, still it may encounter trouble as it is a machine at the end of the day.

What makes a chainsaw run full speed when first starting?

Chainsaw runs full speed when first starting and won’t idle. Just dies | Arboristsite.com Chainsaw runs full speed when first starting and won’t idle. Just dies Okay I don’t know what is going on with my Poulan Pro 50cc.

What to do when your Poulan chainsaw is bogging down?

By adjusting the idle screw, the corrective measure is taken for when the chainsaw is idle. When the chainsaw is unable to hit full power during the full throttle, it’s a good sign that your chainsaw is bogging down. Adjust the high-speed screw to remedy this issue.

What kind of chainsaw does a Poulan 2125 use?

One a poulan 2125 I think, and the other is a poulan pro 35cc. The poulan 2125 was running perfectly about 2 months ago. So the 2125 it starts no problem but high reving with chain going and I can hit throttle and it revs fast but as soon as I let go of throttle it dies.

What happens when you put a load on a chainsaw?

I was milling this last week and all of the sudden the saw would die when at full throttle or die if it would have any type of load put on it at half throttle. Basically it would start and idle just fine, and even sounded good at half throttle but when I would push to mill it would die, and if I tried to go to full throttle it would die.