Is there a problem with the Siemens rwb29 programmer?
Is there a problem with the Siemens rwb29 programmer?
Discussion in ‘ Plumbers’ Talk ‘ started by Banners80, Jun 24, 2015 . When I moved into my house there was a Siemens RWB29 programmer already installed on the wall, I have never had any problems with it until now. However, the screen has now gone blank, it’s as though the battery has died, a bit like when an alarm clock’s battery dies.
How to install the rwb9 programmer on the backplate?
RWB9 Programmer Prior to installing onto the backplate, insert the battery into the battery Next select the mode of system control, ie gravity, hot water with RWB9 Programmer Programming for daily operation (ie same times each day) NB: These units are not suitable for control of immersion heaters. Installation and configuration 1.
What’s the mode of system control in rwb9?
Next select the mode of system control, ie gravity, hot water with pumped radiator circuit (10 mode) (in this case it is not possible to have heating only), or fully pumped with either mid position or zone valves controlling the circulation (16 mode).
Why does my Siemens rwb29 computer screen go blank?
When I moved into my house there was a Siemens RWB29 programmer already installed on the wall, I have never had any problems with it until now. However, the screen has now gone blank, it’s as though the battery has died, a bit like when an alarm clock’s battery dies.
Discussion in ‘ Plumbers’ Talk ‘ started by Banners80, Jun 24, 2015 . When I moved into my house there was a Siemens RWB29 programmer already installed on the wall, I have never had any problems with it until now. However, the screen has now gone blank, it’s as though the battery has died, a bit like when an alarm clock’s battery dies.
Is the Gloworm micron boiler controlled by the rwb9 programmer?
Discussion in ‘ Plumbing and Central Heating ‘ started by Chris Baker, 14 Mar 2018 . Hi all. Please can I ask for some assistance if possible? We have a Gloworm Micron boiler controlled by a Siemens RWB9 programmer. The timer function works correct at the programmer but the boiler runs continuously if allowed to!
When I moved into my house there was a Siemens RWB29 programmer already installed on the wall, I have never had any problems with it until now. However, the screen has now gone blank, it’s as though the battery has died, a bit like when an alarm clock’s battery dies.
How to set combined switching times in rwb9?
To set combined switching times use the TIME+, TIME- buttons, adjust to required time setting (10 minute increments). Press YES to store and move onto next switching time and repeat through each switching time after entering your last OFF. HW, CH and YES/NO flash again, you have completed your programming. Now move the vertical switch to RUN.