What are some safety precautions to take when working with electricity?

They have become very common in modern homes, especially damp areas like the bathroom and kitchen, as they help avoid electrical shock hazards. It is designed to disconnect quickly enough to avoid any injury caused by over current or short circuit faults. 11. Always use a circuit breaker or fuse with the appropriate current rating.

What to do when your water pipes stop working?

Once all the water has stopped running through the system, you need to turn off the faucet at the lowest point in the house. Just that one though. Leave all the other faucets open. You now need to turn the mains water supply back on. Finally, you need to leave the rest of the faucets running in the house.

Do you have to keep heat on to keep pipes from bursting?

If you’re heading out of town, make sure to keep your heat set to no lower than 50 degrees Fahrenheit. Yes, it’s hard to think about paying to keep the heat on while you’re not home. However, you’ll save money in the long run by keeping your house warmer and avoiding burst pipes. Water damage costs thousands to repair.

How to protect your Pipes in the winter?

Here are seven tips to keep your pipes protected during the winter chill: 1. Make Sure Pipes Are Insulated Exposed pipes are prone to freezing, even in warmer climates. There are a variety of ways to keep those pipes snug as a bug in a rug. One way is to add insulation to pipes around the home.

What to do if you have an air lock in your water pipe?

Removing an Air Lock. Increasing the water pressure in the pipe often pushes out the bubble. Try opening all the faucets in the house at once. The increased demand may create enough pressure to do the job. If the lock is affecting the hot water, a simple trick is to disconnect the washing machine and connect the hot and cold valves with one…

How can I solve my hot water airlock problem?

If you have an airlock in the hot water then the most simple way to solve this is to cross the hot and cold water over as shown in the picture above on both of the taps. My hot water is coming through my tap but the cold water isn’t

What causes an air lock in a hot water line?

Description. Because air rises, the place where the bubble forms usually is in the highest section of pipe. The bubble restricts water flow and if it gets big enough, blocks it altogether. Air locks happen most often in hot water lines because they have lower pressure than cold water lines.

What should I do if my air lock is blasted out?

Once you’ve left the two taps running for several minutes you can check to see if the air lock has been blasted out or not. Make sure to undo the pipe from the highest tap first, otherwise the water will come rushing out of the bottom and will absolutely drench you.