What causes a pool pump to lock up?

A frozen pool pump can be caused by two different things. The first, and most common, is that the pump has not been winterized — totally drained of water — and has literally frozen because of low temperatures. The second cause is that the motor bearings have seized up and do not allow the pump motor to turn.

What to do if your pool pump does not fill?

If your pump basket does not fill with water, you’ll have to prime the pump. The good new is it’s pretty straight forward, just follow the steps below: Disconnect any power to the pump and move the diverter valve so that the main drain side is turned to off.

What should I do if my pool drain is not working?

If the main drain is not working in your inground pool, you may need to have it cleaned. To have your pool professionally cleaned (or even if you’re doing it yourself), you’ll need to remove the pool drain cover. However, if there are people in the pool, never remove the drain cover.

Why is my pool pump not working in the summer?

The pump getting baked during the summer months will cause the housing to start petrifying and becoming brittle. Cracks will begin to show around the stress points. The housing is the second most expensive part on a pump to replace, only behind the motor. If the housing and a few other parts need replacing, it may be best to replace the whole pump.

Why is my Intex pool pump not working?

If your Intex pool water level is below the skimmer top, the water getting into the circulation system could combine with air. Solving this problem is easy. All you need is to refill the pool water until it covers the skimmer right. Also, check for debris in the skimmer basket and if you find any, clean them and hose them off.

What do I do if my pump is not working?

Troubleshooting – What to Do If Your Sump Pump Is Not Working? Check the Power Source You can easily check if the socket of the sump pump is live by plugging another appliance into it. Make Sure the Float Switch Is Not Jammed A stuck float switch is a very common problem. Check the Discharge Pipe If the discharge pipe is clogged or frozen, the pump will fail to remove water from your basement.

Why does pool pump not start?

Insufficent electrical supply is the most common reason a pool pump fails to start. If your pump’s motor doesn’t start at all, a lack of power is a likely culprit. Some troubleshooting steps: First, make sure the pump’s switch is set to its ON position.

Why will a pool pump not prime?

There are several reasons why pool pumps tend to lose their prime or are unable to reprime themselves, the most common problem results from air in the pipes or filter. This is usually caused by the pools water level being too low or sometimes is caused by loose fittings or perished o’rings.

Is your pool pump leaking?

If the shaft seal fails, water will leak out. If you’re experiencing a leak in your pool pump, you should have someone take a look at the shaft seal. Inlet Fitting. Your pool pump might be leaking water due to an issue with the inlet fitting. A loose or shrunken thread fitting on the inlet side of the pump can draw air in while the pump is running and leak when the pump is off. The ideal solution here is to replace the fitting.